00056924.DOC, Version 1.1
21/26
Connection between devices
On the rear panel, there is an IEC socket (Power Out). Connect the output with the input of the next fixture
until all fixtures are connected.
Attention:
It is recommended to renew the connection with the power mains after every
8
devices.
Connection with the mains
Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable
Pin
International
Brown
Live
L
Blue
Neutral
N
Yellow/Green
Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.
OPERATION
After you connected the spot to the mains, the EUROLITE LED SCY-200 TCL DMX starts running and the
display lights up.
The device has two operating modes. It can be operated in Stand-Alone or in DMX-controlled mode.
You can choose the desired mode via the buttons MENU, UP and DOWN:
Internal Programs – Auto Mode
Press the MODE button until the display shows
P-
to set the internal programs.
You can choose the desired program (
P – 1
to
P – 10
) via the UP and DOWN buttons:
Press the MODE button again until the display shows an
S-.
Via the UP or DOWN buttons you can set the
desired speed of the program (
S1
bis
S100
).
Sound control
Press the MODE button until the display shows
SoUd
to set the Sound Control Mode.
Setting the Sound Sensitivity
You can do without a controller as the device features a built-in microphone, which provides automatic sound
control. You can adjust the sensitivity with the rotary-control on the rearpanel.
