14
•
EN
Connection of the IR receiver
Connect the IR receiver to the IN jack of the first unit in series.
OPERATION
After connecting the unit to the mains it is ready for operation. The spot is to be controlled via IR-13 remote control.
When actuating a button, always point the remote control in the direction of the sensor at the control unit’s front or
rear. A direct line of sight between the remote control and the sensor is required.
Switching the LEDs on and off
The LEDs can be switched on with the button ON and switched off with the button OFF. However, the spot remains
switched on. After switching on, the LEDs light up according to the last control program selected.
Constant lighting in one color
For constant lighting of all LEDs in one color, press the corresponding color button. Use the buttons in the upper
left corner to adjust the brightness.
Control programs
The control programs can be selected with the respective buttons FLASH, STROBE, FADE and SMOOTH.
Running speed is set to the maximum value when a control program is selected. The speed can be adjusted with
the buttons in the upper left corner.
Notes:
•
The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery
contacts prevents the battery from being discharged during storage. Prior to the first operation remove the foil
from the battery support on the rear side of the remote control. Otherwise operation of the remote control is not
possible.
•
If the range of the remote control decreases, replace the battery. For this purpose, on
the rear side of the remote control press the small bar with the groove to the right and at
the same time remove the battery support. For operation, one 3 V button cell type CR
2025 is required. When inserting, pay attention that the positive pole of the button cell
shows upwards in the support.
•
Remove the battery from the remote control as a precaution if the device is not used for a longer period of time.
R
G
B
W
FLASH
STROBE
FADE
SMOOTH
OFF
ON
Color buttons
Brightness/
Speed
LEDs on
LEDs off
Pulse effect
Strobe effect
Color fading
Color switching
Summary of Contents for LED PST-9W
Page 16: ......
