00125717.DOCX, Version 1.0
23/28
Master/Slave operation
The master/slave operation enables that several devices can be synchronized and controlled by one master
device.
On the rear panel of the device you can find an XLR-jack (DMX Out) and an XLR-plug (DMX In), which can
be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices, which are to be connected to the master device via a DMX cable. Connect the DMX
OUT-jack with the DMX IN-plug of the next device.
Set the desired Master mode “FLAS”, “UL--” or “GOBO for the master device. Set the start address 001 for
all slave devices. Please refer to the instructions under chapter
Control Board
.
EUROLITE IR-13 remote control
1
When actuating a button, always hold the remote control in the direction of the
sensor. There must be visual connection between the remote control and the
sensor.
2
The remote control is supplied with a battery inserted. An insulating foil between
the battery and the battery contacts prevents the battery from being discharged
during storage. Prior to the first operation remove the foil from the battery support
on the rear side of the remote control. Otherwise operation of the remote control
is not possible.
3
If the range of the remote control
decreases (10 meters
as a maximum), replace the
battery. For this
purpose, on the rear side of the
remote control press
the small bar with the groove to
the right and at the
same time remove the battery support. For operation, one 3 V button cell type
CR2032 is required. When inserting, pay attention that the positive pole of the
button cell shows upwards in the support.
Control via IR remote
The IR remote control has several buttons with following functions:
Button
Function
ON
Settings with IR remote control
OFF
Function from Control Board setting
W(hite)
Total brightness; dimmer setting with
STROBE
Strobe effect;
flash rate setting with
SMOOTH
Gobo rotation; speed setting with