23
•
EN
► Automatic mode
1
Press the button
MODE
so many times until
Aut
(Aut0-Aut6) is flashing in the display.
2
Use the buttons
UP
and
DOWN
to select the number of the desired program.
3
Confirm with the
ENTER
button. The display indicates menu item running speed.
4
Use the buttons
UP
and
DOWN
to adjust the running speed of the program from
S 0
(fast) to
S 100
(slow).
5
Confirm with the
ENTER
button.
► Sound control
1
Press the button
MODE
so many times until
Sou
(Sou0- Sou 6) is flashing in the display.
2
Use the buttons
UP
and
DOWN
to select the number of the desired program.
3
Confirm with the
ENTER
button.
4
Adjust the microphone sensitivity to the volume of the music with the control
SENSITIVITY
. The LEDs and the
laser will be switched off after 5 seconds if the volume is too low or if there is no sufficient bass beat.
Master/slave operation with several show lasers
When several show lasers are interconnected (page 21), the slave units can be synchronized and controlled with
the master unit. The units must be set to the corresponding operating modes.
1
Set all slave units to slave mode: Press the button
MENU
so many times until
SLA
is flashing in the display.
Confirm with the
ENTER
button.
2
Set the master unit to the desired show program. The interconnected show lasers will now operate in sync.
DMX operation
► Setting the DMX starting address
For operation with a controller with DMX512 protocol, the show laser is equipped with 7 control channels. To be
able to operate the show laser with a DMX controller, the DMX starting address must be set for the first DMX
channel. The starting address depends upon which DMX controller is being used. Please refer to the controller’s
documentation.
1
Press the button
MODE
so many times until
d
(for DMX) and a number between 001 and 506 is flashing in the
display.
2
Use the buttons
UP
and
DOWN
to set the DMX start address.
3
Confirm with the
ENTER
button. Now the show laser switches to DMX mode and can be operated via the DMX
controller. A dot will flash when DMX signals are being received. If no control signals are available, the DMX
address set will be flashing.
► Functions in DMX mode
DMX value
Function
Channel 1: laser
000 – 009
Blackout (laser off)
010 – 030
Green laser on
031 – 050
Red laser on
051 – 070
Green + red laser on
071 – 160
Automatic running light with green + red laser
161 – 255
Sound-controlled running light with green + red laser
