00025507.DOC, Version 3.0
13/27
ON
POWER SWITCH
OFF
POWER INPUT
FUSE
AC 220V /230V /240V 50Hz 250V 5A
ACHTUNG:
- Vor öffnen des Gerätes Netzstecker ziehen.
- Vor Nässe und Feuchtigkeit schützen.
- Nie ohne Fluid betreiben - Brandgefahr!
- Die Austrittsöffnung nie direkt auf Personen richten.
ATTENTION:
- Débrancher l’appareil avant toute manipulation.
- Protéger de l’humidité.
- Utiliser uniquement du liquide approprié.
- Ne jamais utiliser sans liquide - Danger d’incendie!
- Ne jamais diriger le bec de l’appareil directement sur le public.
WARNING:
- Unplug power cord before servicing.
- Use recommended liquid only.
- Operating this unit without liquid in the tank may
damage the pump.
- Never point directly towards anyone’s face.
- Nur vom Hersteller empfohlene Fluide einfüllen.
- Utiliser uniquement de liquide approprié.
- Please use recommended liquid only.
8
10
9
7
(7)
Attachment eyelet
(8)
Power switch
(9)
Power supply
(10)
Fuseholder
STARTING OPERATION
Install the device on a plane surface.
The liquid tank of the device needs to be filled with foam fluid before starting up operation and always
disconnected from the mains as fluid could be spilled.
Only use quality foam fluids available at your dealer. We recommend high-quality Eurolite Foam fluids (e. g.
EUROLITE Foam Fluid, 5 l). You must not use substances that are classified as "dangerous working
material" or "inflammable fluids".
If fluid should get into the interior of the device, disconnect from mains immediately and consult a technician.
Caution!
Ensure a minimum distance between foam machine and audience of min. 2m. Never direct the
foam output nozzle to the face or the eyes of people.
Installation
Install the device out of the public area. Please consider that liquid may be spilt during operation around the
device. The resulting slippery surface can cause accidents. Keep a minimum distance of 20 cm around and
above the device.
Only install the machine on scratch resistant and water resistant surfaces.
Please make sure that the inclination angle does not exceed 15°.
This device is constructed for a standing or hanging installation. If the device is to be installed overhead, the
following safety instructions are binding:
DANGER TO LIFE!
Please consider the
nd the respective national norms during the
installation! The installation must only be carried out by an authorized dealer!
EN 60335-1:1996 a
The installation of the device has to be built and constructed in a way that it can hold 10 times the weight for
1 hour without any harming deformation.
