EuroLite DYNAMIC FOG 2000, User Manual

Page: 23 / 28

www.eurolite.de
23
Menu Settings
Indication Value Function
Interval set 1-200s Setting time intervals for timer operation
Duration set 1-200s Setting the output duration for timer operation
Timer Out 1-100%/
NONSTOP BURST*
Setting the fog output volume for timer operation
Volume Out 1-100%/
NONSTOP BURST*
Setting the fog output volume for continuous
operation
DMX512 Add 1-512 Setting theDMX512 address
WIRELESS ON/OFF Wireless remote on/off
Fluid Sensor ON/OFF Fluid sensor on/off
* NONSTOP BURST = maximum fog volume
Timer Mode
In the time mode, the fog machine will automatically emit fog. The time intervals, duration and fog volume
depend on the corresponding menu settings. Press the
TIMER button, to activate the timer mode. The
display indicates the set time interval. The unit counts down to 0 seconds and emits fog. To deactivate the
timer mode, press the
TIMER
button again.
Continuous Mode
Press the VOLUME button, to activate continuous fog output. The display indicates Volume followed by the
value that was set in menu item “ Volume Out ” or “ NONSTOP BURST ” when maximum fog volume was
selected. To stop the fog output, press the VOLUME button once again.
Manual Mode
For immediate fog output at the maximum volume of fog, keep the MANUAL button pressed. The display
indicates “ Manual 100 % “. As soon as you release the button, the fog output will stop. The manual operation
will take priority over the continuous operation and the timer operation. Even if one of these operating modes
is activated, the fog machine will always emit the maximum volume of fog when the
MANUAL button is
pressed.
Wireless Remote Control
Press the left button on the remote control to emit fog (continuous
operation with 100 % fog volume). The control LED between the two
button lights. To stop the fog output, press the right button.
If necessary, the wireless remote control can be turned off in the
menu.
If the remote control is not working properly, it must be assigned to the
unit. The remote control can be assigned during a short period of time
after switching on the machine as long as the display shows the
following indication:
To assign the remote control, press and hold one of the buttons until
the display flashes repeatedly, to indicate a match. This can take up to
12 seconds. Thus, the remote control has been assigned to the
machine and may be used for wireless control.