127079.docx, Version 1.0
25/32
OPERATION
After connecting the device to the mains it is ready for operation. The display indicates the last operating
mode. The operating modes can be selected by means of the display and the control buttons. All settings
remain stored even if the device is disconnected from the mains. The device can be operated in stand-alone
mode via the control board or in DMX-controlled mode via any commercial DMX controller.
After you connected the effect to the mains, the EUROLITE LED TSL-1000 Scan starts running. During the
Reset, the motors are trimmed and the device is ready for use afterwards.
Menu structure
Browse through the main menu by pressing
Enter
. Press
Enter
in order to select the desired menu item.
You can change the selection by pressing
Up
or
Down
. Press
Enter
in order to confirm. You can leave every
mode by pressing
Menu
. The functions provided are described in the following sections.
The display shuts off after 10 seconds of inactivity. By pressing any button it lights up again.
Default shown in grey.
Main meun
Sub menu
Function
DMX Address
001~ 512
DMX address setting
DMX Channel
DMX 10 CH / DMX 15 CH
DMX channel mode
Running Mode
DMX
DMX mode
Auto
Auto mode
Sound
Music control
Slave
Master/Slave setting
Programs
Program 1 ~ Program 8
Auto programs
Settings
Pan Rev
YES
PAN reverse
NO
Tilt Rev
YES
TILT reverse
NO
Display Rev
YES
Display reverse
NO
Sensitivity
000-100 Microphone sensitivity
DMX Fail
OFF
Action if no DMX
HOLD
Calibration
Service only
Factory Reset
YES
Reset to factory settings
NO
Reset Motor
Motor reset
System Info
Software V X.XX
Shows the current software version
Mode XXX
Shows the operating mode
Address 001
Shows the DMX starting address
Summary of Contents for 51786122
Page 2: ...2 32...
