00029979.DOC, Version 1.0
17/35
Connection with the mains
Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable
Pin
International
Brown
Live
L
Blue
Neutral
N
Yellow/Green
Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
OPERATION
After you connected the spot to the mains, the EUROLITE LED Floodlight 252 6000K starts running.
STAND ALONE-OPERATION
The LED Floodlight 252 6000K can be operated without a controller.
In order to select
STATIC WHITE
, set dip switch 1 to ON
.
DMX-CONTROLLED OPERATION
You can control the devices individually via your DMX-controller. Every DMX-channel has a different
occupation with different features.
Addressing the device
Set dip switch 10 to ON.
Dip switches 1 - 9 set the DMX address.
Each device occupies 2 channels. To ensure that the control signals are properly directed to each device,
the device requires addressing. This is to be adjusted for every single device by changing the DIP-switches
as set out in the table below.
The starting address is defined as the first channel from which the device will respond to the controller.
Please make sure that you do not have any overlapping channels in order to control each device correctly
and independently from any other fixture on the DMX data link. If two, three or more devices are addressed
similarly, they will work similarly.
