UK-4
RADIO OPERATION
Press the TUNER button (on the unit) or the FUNCTION button(on the remote) to select the Radio
operation.
1. Press the TUNER button to select waveband range will appear on the display.
2. Select the desired waveband range with the STOP/BAND button.
Manual tuning
1. To tune for weak stations, use manual tuning by pressing TUNING / SKIP / SEARCH ( FORWARD
or BACKWARD) button continuously until you read the correct frequency or the reception is at its
best.
2. When you want to select FM stereo station, push FM MODE switch to" ST." status .
When you receive a FM stereo station the " " indicator appears on the display,
you can receiving FM stereo status .
3. When you push the FM MODE switch to the "MONO" status , the FM STEREO indicator will turn
off & in MONO FM status.
Automatic tuning
1. Press the TUNING / SKIP / SEARCH ( FORWARD or BACKWARD) button for a second or more,
then release the button. The tuner will automatically for the first station of sufficient signal
strength.
2. Press above procedure if you wish to select another station.
Programming preset stations
You can also preset stations of your choice and store up to 10 AM and 10 FM stations
in its memory. To store your selected broadcasting stations:
1. Press the STOP / BAND button on the unit(or remote) to toggle between AM and FM to make your
selection.
2. Tune to the required station.
3. Press the MEMORY / C-ADJ button.
4. Press the REPEAT / M-UP button to your desired station number.
5. Press the MEMORY / C-ADJ again to confirm your selection.
6. To program more stations into memory, repeat the above steps 2 to 5.
7. To change the stored preset stations, repeat the above steps 2 to 5.
8. This key is use for setting of memory writing enable state for 8 seconds.
STEREO
Notes:
1. Storing a new station into a preset location will erase the previously stored station in that
location.
2. Power off / failure or power cord disconnection will clear the memory of all preset stations.
Perform the stations presetting procedures again to store the stations.
Selecting the Preset Stations
1. Press the STOP/BAND button to select the desired band.
2. Press REPEAT/M-UP button to select the desired preset station number.
3. The numeric location of that preset station is displayed along with the corresponding frequency.
FM Antenna
FM antenna wire for better FM reception.