U
si
ng Y
ou
r D
S0
01 S
w
ee
per
8
Using Your DS001 Sweeper
Fo
r A
ut
he
nt
ic M
o
ns
te
r R
e
p
la
c
e
m
e
nt P
a
rt
s
Ca
ll
8
88-8
96
-8
78
6
Use Your DS001 Sweeper
Once your DS001 Sweeper has been fully charged and assembled,
it's ready to go to work. Simply slide the large Power Switch on the
Upper Handle and begin using.
Depending on the type of surface being cleaned, the DS001 Sweep
-
er will work for almost 30 minutes using all Brushes. Sweeper may run
for more than 30 minutes when using the single Rear Brush only.
Slide the Power Switch down from the
"Off" position to turn unit On. The Power
Indicator Light above the Battery
Compartment will illuminate "red"
when power is On.
• "LOW" setting is for bare floors.
This
setting uses Rear Brush only.
• "HIGH" setting is for carpeting and
heavily soiled floors.
This setting uses
both Front and Rear Brushes.
With Sweeper speed properly set, simply
pull the Handle toward you to begin.
To stop sweeping at any time, slide the Power Switch to the "OFF"
position. Power Indicator Light will go off, too.
Lift and position the Handle/Extension Tube in the upright position
for storage – it will click into place.
3
CAUTIONS
• Brush Assembly will begin rotating as soon as the Power Switch
is turned on. Make sure the Base is sitting face down on the
floor before turning Power Switch on. Always keep hands, face,
hair, fingers and anything else that may get caught in rollers,
away from Brush Assembly when in use.
• Always remove Charger Jack from the Sweeper before using,
assembling, cleaning, installing or removing Dirt Container.
• Always be sure Dirt Container in installed in unit before use.
• If Dirt Container is full, empty it following the steps on page 9.
IMPORTANT:
CHARGE THE UNIT FOR 16 HOURS BEFORE FIRST USE!
