EUROCOM NIGHTSKY RX15, User Manual, Page: 9 / 35

8
English
RAID Setup Procedure
1. Start-up your notebook computer and press F2 to enter the BIOS
and go to the Setup Utility .
2. Select the Advanced menu.
3. Select SATA Mode , press Enter and select “ Intel RST Premium
With Intel Optane Acceleration ” and select <OK>.
4. Press F10 to “ Save and Exit ” and select <Yes>.
5. After the computer restarts press F2 to enter the BIOS again and
go to the Setup Utility .
6. Go to Intel(R) Rapid Storage Technology (in the Advanced
menu) and select “ Create RAID Volume ”.
7. You can now setup your RAID volume using the installed SSDs.
8. Select “ Name ” and type a name of your choice for your RAID
volume and select <Yes>.
9. Select “ RAID Level ” and choose the RAID Level required (see
Table 1 on page 7 ) and press Enter.
• RAID 0 (Stripe)
• RAID 1 (Mirror)
10. Go to any of the disks listed under Select Disks: and select a
disk name.
11. Click on X to select the disk required.
12. You should select two identical SSDs to form your RAID volume.
13. If you have selected RAID 0 (Stripe) then you can adjust the
“ Strip Size” to your requirements (It is recommended that you
set the “Strip Size” to
128KB ).
14. Select “ Create Volume ” (make sure you have selected your
disks).
15. The system will list your RAID volume.
16. Press F10 to “ Save and Exit ” and select <Yes>, however note
below.
• Make sure the Windows 10 OS DVD is in the attached DVD
drive and as the computer starts up it will automatically boot
from the
Windows 10 OS DVD (you will be prompted to press
a key to boot from the DVD).
17. Click Next > Install Now to continue installing the operating
system as normal (see your Windows documentation if you need
help on installing the Windows OS).
18. Follow the on-screen instructions to install the Windows 10
operating system.
19. Install the Windows drivers (see page 28 ). Make sure you install
the Intel® Rapid Storage Technology (IRST) driver.