![EUROCOM 3400 UltraLite User Manual Download Page 57](http://html1.mh-extra.com/html/eurocom/3400-ultralite/3400-ultralite_user-manual_2437430057.webp)
1
3
4
5
6
7
8
3 – 5
Device Bay:
swaping
BaySwap Utility
Win 9x & BaySwap
Before you begin
If you are using
Windows 9x, make
sure you’ve installed Microsoft
Internet Explorer 4 or 5. These utili-
ties also install components needed
by BaySwap.
1. Insert the Device Drivers & Tools
CD-ROM.
2. Go to the Start menu,
Click on
Run...
>
Browse...
3. Navigate to
D:\drivers\(
YOUR
OPERATING
SYSTEM
)
\bayswap\setup.exe
4. Click on
Open
>
OK
.
5. Select the appropriate language,
then click on
OK
,
Next
,
Yes
or
Fin-
ish
to allow the utility to set itself
up then restart the computer.
6. When the system resumes, the
Bayswap command will appear
in the tray on the lower right side
of the screen.
Windows 2000
This operating system has its own
“swapping system”:
1. Press
á
á
á
á
á
+Break
*>
Hardware
(tab)
> Device Manager
(but-
ton).
2. Highlight the device you want
to remove. (either the “...CD/
DVD-ROM...” or “...LS-120...” or
“ High-Capacity Floppy Disk
Drive”)
3. Click on the right mouse but-
ton, and choose “Disable”.
4. When the list stops refreshing
itself, remove the module and
swap in its replacement.
5. Click on the right mouse but-
ton again, and choose “Scan for
new hardware changes”.
6. After the menu refreshes itself,
should the new device appear
with an “x”, highlight it, click on
the right mouse button, and
choose “Enable”.
7. Close out
Device Manager
,
and use your new module.
Usage:
Right-(mouse) button click on the
icon for an options menu.
Left-(mouse) button click on the
icon for an activity menu.
Hot Method
1. Launch BaySwap from the tray on
the lower-right of the screen.
2. When the
BaySwap dialog box ap-
pears, switch the modules. (Follow
the instructions on page 3-3.)
3. Click on OK to allow the system to
re-scan itself.
Warm Method
1. Put the system in suspend mode
(
F n
+
).
2. Switch modules.
3. Resume full-power mode (press
Fn
+
again).
4. Launch
BaySwap from the tray on
the lower-right of the screen, and
allow the system to detect the
“new” hardware.
*
á
á
á
á
á
+Break =
Start > Control Panel > System
Û
Û
Û
Û
Û