1
2
3
4
5
A
B
B
B – 12
T
HE
S
AVE
-
TO
-D
ISK
FUNCTION
DOES
NOT
WORK
.
possible cause:
The system can’t access the Save to Disk partition.
indicator:
When you press the
Fn
+
key combination, normal
Suspend is activated instead of Save to Disk.
solution:
(1) Make sure you have enabled Save to Disk in the
Power menu in
Setup. Refer to Chapter 4: Firmware.
(2) Set up the Save to Disk partition if you haven’t done
so. Refer to
Chapter 5: Power.
(3) Run the PHDISK utility if you installed a different hard
disk with a Save to Disk partition on it, or there has
been a CMOS or Checksum failure.
T
HE
SYSTEM
NEVER
GOES
INTO
S
USPEND
MODE
.
possible cause:
Power management features are not enabled.
solution:
Go to
Setup’s Power menu and enable the features
you prefer. Refer to the Power Management section of
Chapter 5: Power.
T
HE
SYSTEM
DOES
NOT
GO
INTO
S
USPEND
OR
S
AVE
TO
D
ISK
WHEN
THE
BATTERY
IS
LOW
.
possible cause:
Suspend Timeout is disabled.
solution:
Use one of the Power Management presets or manu-
ally set the Suspend Timeout in the Power menu in
Setup. See Chapter 4: Firmware and Chapter 5: Power.
Troubleshooting:
operation
