4
If the tank is low on water or the feed tap is closed, the "WATER" pilot lamp on the keyboard will flash as to signal the
irregularity.
If after 20 minutes (anyhow programmable time) the problem has not been resolved, the heating will switch off.
To switch it on again the water level must be renewed or the machine reset by turning off and on again.
6) CLEANING THE MACHINE
Before starting any cleaning operation check that the master switch is in off position and that the water temperature
is lower than 40°C.
As food products easily leave perishable residues both on the metal parts with which they come into contact and in
the cooking water, it is important that the machine be carefully cleaned every time it is turned off or at least daily.
Turn off the pasta cooker using the ON/OFF button, unhook the baskets and let them soak inside the tray and pour a
glass of white vinegar into the water. The vinegar will facilitate cleaning when water temperature is below 40°C.
After waiting for the water to cool, remove all the detachable parts in the cooking compartment and wash them. All
parts can be washed in the dishwasher, with the exception of the heating element which must be washed by hand
taking care not to wash the connector.
The internal walls of the machine are easily accessible and can easily be cleaned with a suitable product for
washable surfaces, even without rinsing, not wetting the connector on the left wall.
The probe must be cleaned with a sponge and rinsed.
Regularly empty the drawer-type ventilator condensation tray which is located under the machine. Remember to put
it back in place.
7) MAINTENANCE
If the machine is fed from the reserve water tank, it is advisable to empty and clean it periodically.
To extract it from its base lift it up and disconnect the tube.
8) KEYBOARD MESSAGES
Some possible malfunctions are shown by an error code which appears on the left display together with an
alternating acoustic signal.
In this case the machine remains blocked until conditions return to normal.
Before asking for technical assistance carry out a reset test by turning the machine OFF and then ON using the main
switch.
WARNING
: do not operate with the motor if the basked are not hooked.
Malfunction messages are as follows:
A01
No heating:
The probe may be broken or the connector is wet or the heating relay may be defective.
A02
Probe not connected or temperature too high.
A03
Lack of control of the left motor:
May be the cam on the motor itself has shifted, or the relevant microswitch is broken.
A04
Lack of control of the right motor:
As above
A05
Heating not working properly:
During the heating phase the temperature does not increase within the time foreseen.
A06
Lack of control of the level:
The probe does not read the level or shows a temperature under zero.
A07
Probe short circuiting.
A08
The heating is turned off after a long period without water.
www.linda-lewis.co.uk
0161 633 5797
