- Programming the remote control
Where placing the remote control outside the cellar, having connected the external sensor, it is essential to reprogramme the uni
t
- To turn on the remote control, press and hold down the
key for about 8 seconds until the
indicator goes off.
- First press and continuously hold down the
key, at the same time press and continuously hold down the
key for several seconds until three
lines
appear.The model number is then displayed and flashes.
.
- Press
.
- The
screen appears indicating IN (IN= internal installation). Press the
key to change to OUT external mode.
- The
display appears indicating OUT (OUT= external installation). Press
to confirm.
- The
pictogram appears. Press
.
- The
screen appears. Press
.
- The
pictogram appears. Press
.
-
.appears. Press
.
- The
pictogram appears. Press
.
- The
screen appears, then
.
If you wish to reprogramme the remote control for an internal sensor, disconnect the wired sensor and reprogramme the remote control in internal mode
(IN) by repeating the first two steps described in the paragraph above (see 5-III-b p.11):
The 2nd screen displays
indicating OUT (OUT= external installation). Press the
key to change to IN internal mode. Press
to
confirm.
Then repeat the same steps, as indicated in the above paragraph (see 5-III-b).
c- Fitting
- Fit the remote control and sensor using the screws and pegs supplied (see diagram on page 9, chapter II).
- Place the sensor inside the cellar.
- Place the sensor as close as possible to the bottles
N.B.: the sensor has a range of 3 metres.
9 - I
NSTALLING THE REMOTE CONTROL
17
