EURO One, Operator'S Instruction Manual

Page: 5 / 58

Page A4
Warning Indications
All setting points (Keypads or Tag
Readers) have lamps to clearly
indicate what is happening.
The ‘Alert’ lamp will flash if there is
information available to you. Enter your
code to see the information. After a code
has been entered, one of the following
lamps will light: Alarm, tamper or fault.
The relevant detail of the problem will be
shown on the display. To clear the
display, press the ‘Yes’ key (or the display
will clear automatically after 3 minutes.)
The ‘Alarm’ lamp will flash after code
entry if an alarm occurs.
The ‘Tamper’ lamp will flash after code
entry if the wiring or equipment is
tampered with.
The ‘Fault’ lamp will light after code
entry to indicate if a technical fault
occurs.
The ‘Unset’ lamp will light for 5 seconds if
the panel is completely Unset (steady) or
if some areas remain Set (flashing). It will
also light during the setting procedure,
going off once set.
Alert Alarm Tamper Fault Unset