EURO EV900DPSX Use And Care Manual Download Page 5

Page: 5 / 17

change the injector (see Fig. D) and replace it with another one
suitable for the new type of gas (see Tab. 1)

WARNING:

2nd SECTION FOR THE USER

Fig. D

MINIMUM FLOW ADJUSTMENT FOR HOB-TOP TAPS

In order to adjust the minimum flame setting proceed as follows:
switch the burner on, and set the knob at the minimum position

. . Remove the knob from the tap,

The minimum adjusting screw «Z» is on the body of the gas tap
(Fig. 2).

Unscrew the adjusting screw in order to increase the flow or screw
it to decrease the flow.

The correct adjustment is obtained when the flame has a length
of about 3 or 4 mm.

For butane/propane gas, the adjusting screw must be screwed
in thigt.

Make sure that the flame does not go out turning quickly from the
max. flow

to the minimum flow .

Refit the knob again.

Children should be kept away while the oven or grill is in use
since accessible parts become hot.

WARNING -

During use, the appliance becomes hot.

Care should be taken to avoid touching heating elements inside
the oven.

Do not use oven base panel as a shelf, make use of the oven
shelves.

To avoid splattering and smoke, position collecting tray under
the grill with some water in it.

Always turn pan handles to the side or to the back of the hob.
If they are left out into the room they can easily be hit or reached
by children, this knocking the pan off the hob.

Don't let children sit down or play with the oven door. Do not
use the drop down door as a stool to reach above cabinets.

Once your cooking is over make sure to close the main gas
supply.

WARNING

* This appliance is not intended for use by young children or

infirm persons without supervision.

* Young children should be supervised to ensure that they do

not play with the appliance.

WARNING -

In order to prevent accidental tipping of the appliance, for example
by a child climbing onto the open oven door, the stabilizing means
must be installed.

ELECTRICAL CONNECTION

The appliance must be installed by a suitably qualified person in
accordance with these instructions and with the requirements of
the Australian Wiring Rules AS/NZS 3000.

Fixed wired installations are to be provided with suitable isolation
means in accordance with the said rules.

Any plug socket installed for the purpose of connecting the appliance
to supply must be readily accessible when the appliance is installed.
Before making the connection, make sure that:

1) the safety circuit-breaker and the electrical system are able to

withstand the load of the appliance (see nameplate).

2) the power supply system has an earth connection in good

working order in accordance with the regulations in force;

IMPORTANT

The wires in the mains lead are coloured in accordance with the
following code:

GREEN & YELLOW.........................................................EARTH

BLUE ...........................................................................NEUTRAL

BROWN ...............................................................................LIVE

Electric power ..1,5 mm2 3 core cable (15 amp. Fuse required).
Should conform to local authority requirements.

Also refer to rangehood manufacturers recommendations.

This appliance is supplied with a plug & cord, simply plug into a
3 pin household 15 A socket outlet witch is properly earthed.