6
7
I N S T A L L A T I O N I N S T R U C T I O N S
GAS CONNECTION
The gas inlet is situated at the rear of the appliance, 250mm from
the right-hand side and 58mm from the rear of the cooktop. If
necessary, cut a suitable hole in the back of the cabinet for the
entry of the gas supply and electric cable.
IT IS RECOMMENDED THAT A SERVICE TAP AND UNION BE
FITTED ADJACENT TO THE APPLIANCE INLET TO FACILITATE
FUTURE SERVICING. ENSURE THE REGULATOR SUPPLIED
(FOR NATURAL GAS) IS FITTED BEFORE APPLIANCE.
VERY IMPORTANT FOR THE INSTALLER
Do not attempt to turn or stress the threaded elbow of the manifold:
you risk damage to this part of the gas appliance which may void
the manufacturers warranty.
S E R V I C E I N S T R U C T I O N S
SERVICING FOR HOT PLATES
All service should be carried out be a authorised service technician
only.
GAS CONVERSION AND ADJUSTMENT
When used with natural gas all burners have been preset at our
factory and further adjustment should not be necessary. Conversion
kits to other gases are available from the place of purchase. Do
not attempt to fit the conversion kit yourself. Conversion to U-
LPG or TLP gas should only be carried out by an authorized
technician.
Fig. 5
1 Spark plug for ignition
2 Ignition
3 Switch for ignition
4 Terminal box
Electric diagram
for multi-sparks
lighter
L N
4
3
3
3
3
3
HOB
WARNING: THIS APPLIANCE MUST BE EARTHED.
The flexible mains lead and plug must not be in contact with hot
surfaces.
The wires in the mains lead are coloured in accordance with the
following code:
GREEN & YELLOW.........................................................EARTH
BLUE...........................................................................NEUTRAL
BROWN ...............................................................................LIVE
ELECTRICAL CONNECTION
IMPORTANT
A) On the lower plate of the hob, on the outside there are some
visible screws fixing the burners and the gas manifolds to the
chassis.
Once these screws or screw-nuts are unscrewed, it is possible
to replace the components inside the hob .
B)The hob is fixed in its upper part to the burners by means of
some visible screws. If these screws and the nut blocking the
taps to the hob are screwed, it is possible to open the appliance
and to reach the inside components (see picture below).
WARNINGS
Before performing any repair or operation, switch the appliance
off and close the gas tap.
The manufacturer declines all responsibility for any damage to
persons, animals or things caused by failure to observe the rules
indicated above. In case it is necessary to repair or replace the
inside components, act as follows:
DISASSEMBLY OF WORK-TOP
- disconnect the electrical supply cable
- disconnect the gas supply tube
- remove the grids
- remove burners and flame-spreaders
- remove the knobs from the facia-panel
- disassemble the work-top from the cabinet unscrewing screws
blocking locking bridles.
Remove the hob from the top.
This hotplate is supplied with a plug & cord, simply plug into
a 3 pin household socket outlet which is properly earthed.
In order to avoid hazard, any electrical work performed on
this equipment or its associated wiring, should only be done
BEFORE LEAVING
Check all connections forgas leaks with soap and water. DO NOT use
a naked flame for detecting leaks. Ignite all burnersto ensure correct
operation of gas valves, burners and ignition. Turn gas taps to low
flame position and observe stability of the flame. When satisfied with
the hotplate, please instruct the useron the correct method of operation.
In case the appliance fails to operate correctly after all checks have
been carried out, refer to the authorised service provider in your area.
by persons authorised by the supplier or similarly qualified
persons.
