Euro Shatal PS353-100, Operating Instructions/Spare Parts List

Page: 8 / 28

PS353-100; PS353-120 -7- APR.2015
SEE PICTURE 1-6 PAGE 16
SEE PICTURE 7-11 PAGE 16
1.
Disconnect the machine by unplugging the supply cable.
2. The blade locking nut has a left- hand thread.
3. Check that the blade is assembled correctly. Check that the arrow marked on the blade is in the same direction as the arrow on the blade guard.
4. Use the tools that supply with the machine to assembled and diassmbled the blade.
SEE PICTURE 12-14 PAGE 17
The side table(?)can be used as an extension or as a stopper. After assembly tightening the wing nuts(?).
SEE PICTURE 15; 19 PAGE 17
Loosen handle (C) on both ends of the machine.
Tilt over the cutting head and rail assembly.
Close handle (C).
Adjust the cutting depth if required using handle (D).
SEE PICTURE 16-18 PAGE 17
Move the cutting head to the rear.
For long parallel cuts fit the longitudinal guide (E) parallel and at the correct distance from the blade.
Place the material on the clean table.
Pull the head towards you carefully without undue force.
Avoid sudden contact with the material.
SEE PICTURE 19-20 PAGE 17
Release lever (D) and adjust the head using handle (G) until the required cutting depth is achieved. For normal cutting, adjust the height so that the blade is 5mm
below the top of the table. Retighten the lever (D).
SEE PICTURE 20-22 PAGE 17
Put cutting head in upper position. Release knob (F), slide table sideways and then upwards, remove the table.
- ELECTRICAL SAFETY:
Operate this machine only on a supply equipped with a 30 mA earthed current-limiting earth leakage relay.
- Make sure that the mains voltage corresponds with that marked on the manufacturer’s plate on the machine.
- Use the following types of plug, single phase 2 P + E, according to the corresponding voltage.
-
Extension lead: Cable size sufficient for the electrical power, connection to the mains by a H07 RNF type cable of the following size: 3 x 2.5 mm² up to
50m for 230V.
Always pay extreme care and attention to the preparation of the machine before starting up.
Remove all adjustment tools and wrenches from floor and machine.
Always keep blade guard in place.
•
Fill the water tank.
•
The water pump should be covered with water all the times as without it there is no cooling and it will overheat and burn.
As each machine is fitted with a self-priming pump, the water is sprayed onto the blade as soon as the machine starts.
∗
To start the machine press the green button.
∗
To stop the machine, press the red button.
TRANSPORT TO WORK SITE
ENGLISH
FITTING OF THE CUTTING DISC
OPERATION
Ensure that the water supply is abundant
Please Do not lift the machine from the head or rail
ELECTRICAL CONNECTION
FITTING THE SIDE TABLE
45º BEVEL CUT
CUTTING METHOD
DEPTH OF CUT ADJUSTMENT
REMOVING TABLE FOR MAINTENANCE