OPERATING INSTRUCTIONS
GETTING TO KNOW YOUR CYCLONIC BAGLESS
UPRIGHT
Technical Specifications
Voltage:
120V., 60Hz.
Power:
12 Amps
1. Upper Handle
2. On/Off Switch
3. Dust Cup Release Button
4. Dust Cup
5. HEPA Filter Frame
6. Carpet Height Selector
7. Furniture Guard
8. Head Light
9. Motorized Power Head
10. Flexible Hose
11. Power Cord
12. Quick Release Power Cord Holder
13. Round Brush
14. Upholstery Brush
15. Crevice Tool
16. Extension Tubes (x2)
17. Hose Connector
18. Carpet-to-Floor Selector
3
Note: Illustrations may differ from actual unit.
Important
:
This unit is equipped with a
motor protective thermostat. If for some
reason the vacuum cleaner should
overheat, the thermostat will automatically
turn the unit off. Should this occur:
•
Push the On/Off button once.
• Disconnect the plug from the
power source.
• Check the source of overheating
problem. (i.e. clogged hose or filter)
• If clogged hose or filter is found,
unclog the hose and replace the
filters.
• Wait at least 45 minutes before
attempting to reuse the vacuum.
• After unit has cooled down for 45
minutes, plug in the cleaner and push
the On/Off button. The vacuum should
start again.
• If the vacuum still does not start,
contact customer service at
1 (800) 798-7398.
Cleaning & Changing the Belt
Warning:
To reduce the risk of electric
shock, the power cord must be
disconnected before removing the dust
cup, HEPA filter,changing the filters or
performing maintenance/trouble shooting
checks.
Occasionally the power nozzle drive belt
will require changing, the frequency will
depend upon the amount of use your
vacuum sees.
1. Turn the vacuum "Off" and unplug
from power supply.
2. Turn the vacuum upside down on a
flat level surface.
3. With a coin or a thick flat head
screwdriver, unlock the two (2)
screw locks by turning counter-
clockwise. (Fig. 21)
Motor Thermostat
4. Remove the bottom cover of the power
head.
5. Lift the right side of the agitator brush
first and then lift the left hand side and
lift the agitator brush out of the power
head.
6. Carefully remove any belt residue that
may exist in the belt area.
7. If the belt has broken, remove any
loose pieces before replacing with a
new belt.
8. Remove the worn or broken belt from
the motor drive shaft.
9 Loop the new belt first over the motor
drive shaft and then over the agitator
pulley. (Fig. 22)
Insert
First
Fig. 22
10. Insert the left side of the agitator in
first by placing the end cap down into
the slot and then do the same with the
right side. Press firmly to make sure
that each end is completely inserted.
11. Check to make sure that the belt is
centered on the pulley and that the
agitator turns freely.
12. Replace the top cover over the power
head base and lock in place by turning
the two screw locks clockwise until you
hear them lock in place.
Fig. 21
4. Remove the bottom cover of the
power head.
5. Lift the right side of the agitator brush
first and then lift the left hand side and
lift the agitator brush out of the power
head.
8
