OPERATING INSTRUCTIONS
PRECAUTIONARY MEASURES
Changing the Headlight Bulb
Notches
Important
:
If the suction opening in the unit, the hose or the extension tube become
blocked, switch off the vacuum cleaner and remove the blocking
substance before you start the unit again.
Warning:
To reduce the risk of electric
shock, the power cord must be
disconnected before removing the dust
cup, HEPA filter,changing the filters or
performing maintenance/trouble shooting
checks.
5.
When pulling out the power plug
from the wall outlet, pull the plug
not the power cord.
1.
Do not operate the vacuum
cleaner to close too heaters,
or radiators.
1. Turn unit “Off” and unplug from wall
outlet.
2. With a flat head screw driver, snap
off the lens cover by pressing down
on the two notches on the lens
cover. (Fig. 23)
3. Lift off the head light lens.
4. Remove the light bulb by pulling it
out carefully.
5. Replace the new bulb by pushing
it in.
6. Replace the head light lens by
pushing it in so that it snaps back in
place.
Fig. 23
PROBLEM SOLVING
6.
Do not pick up anything that is
burning or smoking such as
cigarettes, matches or hot ashes.
This appliance was inspected thoroughly and was in good operating condition when it
was shipped from the factory. If a minor problem occurs, it usually can be solved quite
easily when the cause is found. Therefore, this checklist is provided for your
convenience.
2.
Before inserting the power plug
into the wall outlet, make sure that
your hands are dry.
7.
Do not run appliance over power
cord.
9
PROBLEM POSSIBLE
CAUSE
POSSIBLE
Cleaner Won’t
Run
1. Not properly plugged into wall
outlet.
2. No electricity in wall outlet.
3. On/Off switch not turned on.
4. Motor thermostat tripped.
5. Blown
fuse/tripped
breaker.
1.
Plug in firmly.
2.
Check fuse or breaker.
3.
Push on/off switch to on
4.
Reset motor thermostat.
(page 8 )
5.
Reset circuit breaker or replace fuse.
Cleaner Won't
Pick Up
1. Full or clogged dust cup.
2. Wrong pile height setting.
3. Clogged
nozzle.
4. Clogged dust inlet port.
5. Clogged
hose.
6. Broken
belt.
7. Hose not inserted fully.
8. Dirty
filters.
1.
Clean dust cup. (page 5)
2.
Adjust setting. (page 5)
3. Remove
obstruction.
4.
Remove power head cover and
remove obstruction.
5. Remove
obstruction.
6.
Replace belt. (page 8)
7.
Push hose in securely.
8.
Clean / change filters.
(page 6, 7)
Cleaner Picks Up
Moveable Rugs
Or Pushes Too
Hard
1. Wrong pile height setting.
1.
Adjust setting. (page 5)
Agitator Does Not
Turn
1. Broken
belt.
2. Belt
installed
incorrectly.
1.
Replace belt. (page 8)
2.
Check belt changing and agitator
cleaning. (page 9)
Air Flow
Restricted With
Attachment Use
Sound Changes
1.
Attachment use restricts air
flow.
2. New
carpet
debris
clogging
air path.
1.
Check attachment.
2. Remove
obstruction.
3.
Do not vacuum any liquids.
8.
Do not use without dust cup
filter or filters in place.
9.
Before you start vacuuming,
make sure to remove large or
sharp objects that might
damage the vacuum.
4.
Keep hair, loose clothing, fingers,
feet and all parts of body away from
openings, rotating agitator and other
moving parts.
2
