39
EN
Warning!
During operating, the product generates an electromagnetic field which, under certain
circumstances, may impair the functionality of active or passive medical implants. To
reduce the risk of serious or lethal injuries, we recommend that persons with medical
implants consult their doctor and the manufacturer of their medical implant before
operating the electric tool.
BEFORE USE
Unpacking
1. Unpack all parts and lay them on a flat stable surface.
2. Make sure the delivery contents are complete and free of damage. If you find that
parts are missing or show damage, do not use the product but contact your dealer or
the service center. Do not use the product unless missing parts have been delivered
in addition or defective parts have been replaced. Using an incomplete or damaged
product represents a hazard to people and property.
3. Ensure that you have all the accessories needed for assembly and operation.
Charging the battery pack (Fig. B)
Note:
• The battery can be damaged in case of improper charging.
• Remove the charger's mains plug before inserting or removing the battery.
The battery is partially charged upon delivery to avoid damage to the battery caused by a
deep discharge. Prior to initial start-up and when the battery is low, the battery should be
charged. To do so, please proceed as follows (Fig. B):
1. Slide the battery pack (11) onto the charger (15) upside down till it locks in place.
2. Insert the mains plug of the charger (15) into a properly fused mains socket. The RED
charge control LED (17) is illuminated; and charging requires approx. 60min.
3. Wait until the RED charge control LED (17) goes out and green charge control LED (16)
is illuminated, the battery is fully charged.
4. Hold onto the mains plug while pulling the power cable of the charger out of the mains
socket. The battery pack (11) and the charger (15) may have become warm during
charging, allow the battery cool down to room temperature.
5. Take the battery pack (11) out of the charger (15) by pressing and holding the battery
release button (14) and pulling the battery pack (11) out of the charger (15).
Removing /Inserting the battery
1. To remove the battery pack (11) from the tool, press the battery release button (14) on
the battery pack (11) and pull the battery out.
2. To insert the battery pack (11), place it on a guide track and push it back into the tool. It