27
EN
Service
a)
Have your power tool serviced by a qualified repair person using only identical
replacement parts.
This will ensure that the safety of the power tool is maintained.
b)
Never service damaged battery pack.
Service of battery packs should only be performed
by the manufacturer or authorized service providers.
Specific safety warnings for Reciprocating Saw
•
Hold the power tool by the insulated gripping surfaces, when performing an operation
where the cutting accessory may contact hidden wiring.
Cutting accessory contacting
a “live” wire may make exposed metal parts of the power tool “live” and could give the
operator an electric shock.
•
Wear a dust mask
•
Use Clamps or another practical way to secure and support the workpiece to a stable
platform.
Holding the workpiece by hand or against your body leaves it unstable and my
lead to loss of control
Special safety instructions for battery-operated tools
a)
Ensure that the tool is switched off before inserting the battery.
Inserting a battery into
a tool that is switched on may result in accidents.
b)
Recharge the batteries indoors only because the battery charger is designed for indoor
use only.
Risk of electric shock.
c)
To reduce the electric shock hazard, unplug the battery charger from the mains before
cleaning the charger.
d)
Do not subject the battery to strong sunlight over long periods and do not leave it on a
heater.
Heat damages the battery and this is risk of explosion.
e)
Allow a hot battery to cool before charging.
f)
Do not open up the battery and avoid mechanical damage to the battery. Risk of short
circuit and fumes may be emitted that irritate the respiratory tract.
Ensure fresh air
and seek medical assistance in the event of discomfort.
g)
Do not use non-rechargeable battery.
This could damage the appliance.
h)
The recommended ambient temperature range for the charging system during
charging is from 4ºC to 40 ºC.
i)
The recommended ambient temperature range for tool and battery storage is from 0ºC
to 50 ºC.
j)
The recommended ambient temperature range for tool and battery use is from -15ºC
to 60 ºC.
k)
Remove the battery from the device before storage.
l)
Electrolyte leaking from the cells can cause damage to the skin, clothes or any other
items exposed to it. If the electrolyte contacts the skin or clothes, wash thoroughly
with clean water. If the electrolyte enters into the eyes, do not rub the eyes but flush
them immediately with copious amounts of clean water such as tap water, and
immediately consult a doctor.
m)
Do not disassemble or modify the battery, which can cause short-circuiting between
