w w w . e u r e k a t e n t s . c o m f a x : 6 0 7 . 7 7 9 . 2 2 9 1
R E V . C 1 . 0 7
Note: Install perimeter tubing at the same angle
as the roof pitch. Raising the crown will help
draw last corner together.
See fi g. 5.
• Install the perimeter sections in sequence by
connecting the perimeter tubing from one bracket
to the next.
•
Permanent Cable
— If using permanent cable,
attach the loop of the longer cable around the
intermediate bracket arm before sliding the arm into
the perimeter tubing. See below.
•
Non-Permanent Cable
If using non-permanent
cable, attach with a carabiner around the arm of the
intermediate bracket. [ use longer cable ]
See below.
Frame assembly on the ground is comp lete.
4. Cable assembly- permanent
See fi g. 6.
• Loop the short cable over the crown and allow it
to hang straight down.
• Connect the short vertical cable to the long
horizontal cable. Adjust turnbuckle to assure that
the cable is tight.
5. Position the top over the frame
• Pull the top [ top sections ] onto the frame.
• Lace tent sections together [ Sectional Tent see
appendix A in the reference section ].
• Align the tent top on the frame. Check the
corners, hip areas and crowns to make sure the top
is square on the frame.
• Place the web straps from the tent top through
the channels on the corner and intermediate
brackets. Feed the web through the buckle and
pull down until the buckles are positioned in the
channels.
Note: Buckle must fall into channel. Buckle
can be broken if allowed to ride on corner of
channel.
See photos below.
fi g.5
Slide perimeter tubing until it hits the stop-
Pin the tubing with a Silver Pin
Loop the short cable over the crown and
allow it to hang down
Pull web until
snug and buckle
is in channel
Take web back
through buckle
Thread web around
D-ring
Correct
angle
Incorrect
angle
fi g.6
