SURE FROM AQUAGUARD
®
DELIGHT NXT RO+UV+TA TECHNICAL SPECIFICATIONS*
DELIGHT NXT
i-Filter
™
Multi-Layered Polypropylene
Roving Wound Cartridge
Removes suspended particles such as dirt, dust, mud and sand from
water.
Chemi-block
(with built-in
Particle Trap Filter)
Adsorbs colour, odour, excess chlorine & organic impurities from the
incoming water. It removes very fine turbidity from the water. Its
unique Particle Trap Filter entraps any released micro particles.
Dust-free Bacteriostatic Activated
Carbon block filter cartridge with
built-in Particle Trap Filter
2.
1.
Membrane Life
Enhancer***
Prevents scaling of dissolved salts on the surface of the membrane,
thereby, enhancing the membrane life and performance
Special Anti-scalant Media
3.
Reverse Osmosis
Cartridge
Reduces TDS, hardness, pesticides and heavy metals like arsenic,
lead and mercury. Eliminates microorganisms like bacteria, viruses,
protozoa and cysts.
Thin Film composite (TFC) reverse
osmosis membrane
4.
UV e-boiling
™
UV disinfects the water by eliminating waterborne disease-causing
bacteria, viruses & protozoa, thereby, making it safe to drink.
Germicidal UV Lamp
5.
6.
Post Carbon
™
Cartridge
Removes residual organic impurities and revives the original taste
of water. The carbon granules polish the water, giving it a sparking
look, making it pure and great to taste.
Carbon Block Filter
7.
TDS Regulator
Adjusts the TDS of purified water to provide healthy water always
Mechanical System
***
Not a part of the product, Membrane life enhancer is recommended If the input water TDS is more than 1000ppm (mg/L) or input water hardness is more than 300ppm
(mg/L). Available at an extra cost.
*Technical Specifications are subject to change without prior notice.
Note: The performance data presented in the table is applicable under standard
laboratory conditions
#
. Actual performance may vary depending on the input water
quality, water pressure and condition of filters. Input water quality/pressure/TDS are
important determinants of recovery rate and rejection.
Warranty void if product not installed as per recommendations.
**If the input water pressure is more than 3 kg/cm
2
, installation of a PRV (Pressure
Reducing Valve) is mandatory. If the input water pressure is less than 0.3 kg/cm
2
,
installation of a booster pump is recommended.
++
If the input water TDS is more than 1000 ppm (mg/L) or input water hardness is more
than 300 ppm (mg/L), use of a Membrane life enhancer is recommended.
These accessories are available at an extra cost.
#
Standard Test Conditions:
Feed Water Quality: TDS Max: 1000 mg/L with NaCl.
Pressure: 1 kg/cm
2
, Turbidity: 1 NTU (Max.), Temperature: 25°C, Chlorine: below 0.2
mg/L, Iron: below 0.3 mg/L
Life: 6000
#
Litres. Pressure on membrane: 75 psi & Product recovery @ 25%
Technical Parameters
Model
1.
1.
2.
3.
4.
5.
1.
2.
3.
4.
5.
6.
1.
2.
3.
4.
5.
6.
7.
Sure from Aquaguard
®
Delight NXT RO+UV+TA
PRODUCT SPECIFICATIONS
ELECTRICAL SPECIFICATIONS
RECOMMENDED INPUT WATER PARAMETERS
Dimension (W X D X H)
Net Weight
320mm X 270mm X 480mm
Purification Technology
RO+UV+TA
Power Rating
40 Watts (max.)
Power Supply
Input 230 VAC / External AC-DC Adaptor,
24 V DC, 2.5 Amps
UV LAMP
4 Watts
UV LAMP Life
5000 burning hours
(as per manufacturer’s spec.)
Operating Voltage Range
Solenoid Valve
150 to 250 V AC, 50 Hz
24V DC
Input Water Pressure (Max.)**
0.3 to 3 kg/cm²
Input Iron (Max.)
0.3 mg/L
Chlorine Content (Max.)
0.2 mg/L
Input Water Turbidity (Max.)
5 NTU
Total Dissolved Solids (TDS)
Up to 2,000 mg/L
++
Water Temperature
Total Hardness
600 mg/L
10°C to 40°C
Tank Capacity
6.2 Litres
Standard Filtration Supplied
i-Filter
TM
, Chemi Block, RO Membrane,
UV e-boiling
TM
, Post Carbon Cartridge,
TDS Regulator
6.7 kg (Approx.)
Sr. No.
Specifications
