Make sure that your Aquaguard
®
Select
EDGE
with Stainless Steel is installed by a trained
Eureka Forbes Service Technician only.
1. Input water must be tested for Total Dissolved Solids (TDS).
2. Install your water purifier in a suitably ventilated place. Keep it away from direct sunlight,
heating devices or areas below freezing temperature. You can keep it on the kitchen counter or wall
mount it.
3. Ensure that the input water temperature is in the range of 10°C – 40°C. Do not connect to a hot water
tap as it can damage the filters.
4. Make sue that the tap water pressure is between 0.3 kg/cm
2
to 2.0 kg/cm
2
for Aquaguard Select Edge
SS UV and not exceeding 3.0 kg/cm
2
foe Aquaguard Select Edge SS RO+UV+MTDS.
5. After installing, run the purifier for 5-10 mins.
6. Make sure that the rejected water pipe (blue coloured pipe available in Aquaguard
®
Select
EDGE HD RO+UV+MTDS model only) is placed lower than the purifier, to avoid stagnation of
high TDS reject water in the pipe.
7.
MTDS Regulator Operating Procedure
: TDS Modulator is located inside the product. As per factory
setting, it comes in completely closed mode. The TDS level of output water can be increased by slowly
loosening (turning anti-clockwise) the spindle of the TDS modulator. Normally, a slight quarter turn is
enough to increase the TDS of output water. Rotating the spindle in clockwise direction closes the
TDS modulator, and reduces the level of TDS blending. Please note that TDS blending and its
adjustment is dependent upon the level of TDS of input water and on the TDS reduction capacity of
the RO Membrane. TDS adjustment should be done by a company authorised personnel only.
INSTALLING YOUR WATER PURIFIER
®
®
