TECHNICAL SPECIFICATIONS* OF AQUAGUARD
®
SELECT
EDGE WITH UV WITH STAINLESS STEEL.
#
Technical Parameter
Specification
1
Model
Aquaguard
®
Select EDGE SS UV+AC
PRODUCT SPECIFICATION
1
Dimension (W X D X H)
356mm X 268mm X 528mm
2
Net Weight
8.5 KG. (approx.)
3
Purification
Technology
UV
4
Tank Volume
5 litres (approx.)
5
Purification Stages /
Additional Features
Stage 1 : HD - Filter
TM
Stage 2 : Mineral Guard
TM
Stage 3 : Chemi-Block
Stage 4 : UV Lamp (11 Watts)
Stage 5 : Active Copper Maxx
TM
Stage 6 : Biotron
TM
1
ELECTRICAL SPECIFICATIONS
1
Power Rating
20 Watts(max.)
2
Power Supply
External Power Supply-230 VAC Input, Output DC Supply-12V, 1.7 A
3
UV Lamp
11 Watts
4
Operating Voltage Range
8,000 burning hours (as per UV lamp Manufacturer's spec.)
5
UV Lamp Life
150 to 250 VAC, 50 Hz
5
Solenoid Valve
12V DC-PL 6 Stem
RECOMMENDED INPUT WATER PARAMETERS
Input Water Pressure range***
0.3-2.0 kg/cm
2
2
Input Iron (max.)
0.3 mg/L
3
Chlorine Content (Max.)
0.2 mg/L
4
Input Water Turbidity (Max.)
5 NTU
Up to 200 mg/L
10 C to 40 C
5
Total Dissolved Solids (TDS)
6
Water Temperature (range)
*Technical Specifications are subject to change without prior notice.
Note: The performance data presented in the table is applicable under standard laboratory conditions
#
.
Actual performance may vary depending on the input water quality, water pressure and condition of filters.
Input water quality/pressure/TDS are important determinants of recovery rate and rejection.
Warranty void if product is not installed as per the recommendations.
**If the input water pressureis more than 2.0kg/cm
2
, installationofa PRV (Pressure Reducing Valve)*
is mandatory. If the input water pressureisless than 0.3kg/cm
2
, installationof booster pump* is
recommended. The seaccessories are available at an extra cost.
#
Standard Test Conditions:
Feed Water Quality: TDS: 200 mg/L with NaCl.
Pressure: 1 kg/cm
2
, Turbidity: 1 NTU (Max.), Temperature: 25º C,
Chlorine: below 0.2 mg/L, Iron: below 0.3 mg/L
Life: 6,000
#
Liters.
