#
TECHNICAL PARAMETER
SPECIFICATION
Model
AQUAGUARD
®
MIST UV+
PRODUCT SPECIFICATION
1
Dimension (W X D X H)
310 mm X 170 mm X 400 mm
2
Net weight
3 Kg (Approx.)
3
Purification Technology
UV
4
Standard Purification supplied
Combination cartridge, UV- E-boiling
TM
,Mineral
Charge Cartridge
ELECTRICAL SPECIFICATIONS
1
Power Rating
18 Watts (Max.)
2
Power Supply
Input 230V AC, 50 Hz
3
UV LAMP
8 Watts
4
UV Lamp life
8000 burning hours (as per UV lamp manufacturer spec.)
5
Operating Voltage Range
150 to 280 V AC, 50 Hz
RECOMMENDED INPUT WATER PARAMETERS
1
Input water pressure range**
0.3 to 2 kg/cm
2
2
Input Iron content (Max.)
0.1 mg/L
3
Input Chlorine content (Max.)
0.2 mg/L
4
Input water turbidity (Max.)
5 NTU
5
Total Dissolved Solids (TDS)
Up to 200 mg/L
6
Input Water Temperature range
10°C to 40°C
*Technical Specifications are subject to change without prior notice.
Note: The performance data presented in the table is applicable under standard
laboratory conditions
#
. Actual performance may vary depending on the input
water quality, water pressure and condition of filters.
** If the pressure is lower than minimum specified, use an external booster pump
is recommended.If the pressure is higher than the maximum specified, use of a
pressure reducing valve is mandatory.
The above accessories are available with our company at an additional cost.
Performance
data
sheets
are
available
with
Eureka
Forbes
Technical
Documentation Centre.
Warranty void if the product is not installed as per recommendations.
#
Standard Test Conditions:
Feed Water Quality: TDS Max: 200 mg/litres with NaCl Pressure: 1.0 kg/cm
2
,
Turbidity: Max.1 NTU, Temperature: 25
°
C, Chlorine: below 0.2 mg/litres,
Iron: below 0.3 mg/litres.
#
Actual performance may vary based on the input water conditions - TDS,
Pressure, Temperature & pH. Standard test Condition are valid for online water
supply installation.
TECHNICAL SPECIFICATIONS*
Summary of Contents for Aquaguard MIST UV+
Page 1: ...MIST UV...
Page 10: ......
