Product installation should be done only by a trained Eureka Forbes Service Technician only.
1.
Input water must be tested for Total Dissolved Solids (TDS) and Total Hardness
- Install the product in a dry ventilated place. Keep it away from direct sunlight, heating devices or areas below 10
o
C.
- The purifier should be placed in area which is free of ants/insects/other pests.
- Ensure that the input tap water temperature is in the range of 10
o
- 40
o
C. Avoid installation to a hot water tap as it can damage the filters.
2.
The input water pressure to your water purifier should be within the recommended range (refer variant specific technical specifications table). If
the input water pressure is more than specified, installation of a PRV (Pressure Regulating Valve)** is mandatory. If the input water pressure is
less than specified, installation of an external booster pump** is recommended.
3.
Ensure that the filters are flushed thoroughly and independently for 3-5 minutes to remove fine particles present in the filter, before the installation
of the unit.
4.
After installation, run the purifier for 5-10 minutes and drain the water.
Input water quality usage limitations:
1.
If the input water iron content is more than that prescribed in the technical specifications, use of an iron remover** is recommended as a pre-
treatment.
2.
If the input water turbidity is more than that prescribed in the technical specifications or comprises colloidal particles, use of a special filter** is
required as a pre-filter.
3.
If the input water TDS is more than 1,000 ppm (mg/L) or input water hardness is more than 300 ppm (mg/L), use of a Membrane life enhancer**
is recommended (applicable only for RO variants).
4.
Do not install the water purifier if the TDS is more than that prescribed in the technical specifications.
**Available at an extra cost.
PRE-REQUISITES FOR INSTALLATION
Summary of Contents for Aquaguard MIST UV+
Page 1: ...MIST UV...
Page 10: ......
