11
2090276-10-12/20 (translation of the original operating instructions)
Operating Instructions
Rope Pull Switches RPS…
EN
3
Fasten the RPS switch with 4 M5 screws (also M6 for
RPS-M).
Maximum tightening torque M = 2 Nm.
The emergency stop switches must be positioned so that
the rope or emergency stop slam button can be reached
without obstacles in hazardous situations.
17
85,5
72
40
48
10
Display
Display
4
A
Display
Connect pull rope with fast-action clamping head (see Item 1).
Pre-tension pull rope.
B
Connect pull rope with turnbuckle as shown (3x rope clamp with thimble)
5
Basic setting should take place at a temperature corresponding to the prevailing operating conditions.
The length of the pull rope changes if there is a large change in the ambient temperature. Under these conditions,
long rope lengths mean a frequent change in the basic setting.
This can be remedied by re-adjustment (Item 5) or shortening the rope length (Table 3).
A
SW17
Adjusting screw
Remove any leg spring. If necessary, manually adjust the
rope length with the adjusting screw or a flat wrench (a/f
17) by turning the screw in until the arrow tips of the
rope
tension
display align with the marking.
Hold the fast-action clamping head when doing this to
prevent the pull rope from twisting.
Subsequently insert a leg spring or secure the adjusting
screw against loosening by locking with the hexagon nut.
Display
B
Adjust the turnbuckle until the arrow tips of the display align with the marking.
