MD-649 User Manual
35
it to "TCP". Please make sure to set the same
communication protocol in MD-649 as in mServer
if you want to change it.
2)
Listening port:
set the port that MD-649 uses to
establish connection to mServer. In case of single
host accessing the internet, the port set in
MD-649 is the listening port in mServer. The value
can be 0 ~65535. It is recommended to set port
number with more than 2000, to avoid port
conflict with other applications.
"DCC Connection Settings" part: used to set related
parameters that mServer client software DCC
connects to mServer.
1)
"
Allow DCC connection
": checkbox. Check is item if
the DCC is allowed to connect to mServer, and then
set the number of DCC clients that can connect to
mServer and the port used to connect to mServer.
This port is used to listen DCC's connection to
mServer, while the listening port in the description
above is used to listen MD-649's connection to
mServer, these two ports must not be the same!
2)
"DCC Authentication Required": checkbox.
Please check this item if authentication is required
when DCC connects to mServer, then set the
username and password that DCC client need to
provide when connecting mServer.
What is DCC?
DCC is the brief description of Data Center Client, and is
a program that connects to mServer via DCC interface
and implements some special features.
Step 2: Configure MD-649 parameters
Refer the description in chapter 2 to configure MD-649. In this
usecase, set domain as www.chuankoutong.com, and port as 8080,
and set default values for serial port.