MD-309 User Manual
38
it to "TCP". Please make sure to set the same
communication protocol in MD-309 as in mServer
if you want to change it.
2)
Listen port:
set the port that MD-309 uses to
establish connection to mServer. In case of single
host accessing the internet, the port set in
MD-309 is the listening port in mServer. The value
can be 0 ~65535. It is recommended to set port
number with more than 2000, to avoid port
conflict with other applications.
"Interface Settings" part: used to set related
parameters that mServer client software DCC
connects to mServer.
1)
"
Allow DCC connection
": checkbox. Check this item
if the DCC is allowed to connect to mServer, and then
set the number of DCC clients that can connect to
mServer and the port used to connect to mServer.
This port is used to listen DCC's connection to
mServer, while the listening port in the description
above is used to listen MD-309's connection to
mServer, these two ports must not be the same!
2)
"DCC need Authentication": checkbox.
Please check this item if authentication is required
when DCC connects to mServer, then set the
username and password that DCC client need to
provide when connecting mServer.
What is DCC?
DCC is the brief description of Data Center Client, and is
a program that connects to mServer via DCC interface
and implements some special features.
Step 2: Configure MD-309 parameters
Refer the description in chapter 2 to configure MD-309. In this
usecase, set domain as www.chuankoutong.com, and port as 8080,
and set default values for serial port.
Summary of Contents for MD-309 2G DTU
Page 8: ...MD 309 User Manual 8 Figure 1 5 9 pin and 9 hole direct serial line Figure 1 6 Power supply ...
Page 9: ...MD 309 User Manual 9 1 4 Dimensions Figure 1 7 MD 309 dimension with shell ...
Page 40: ...MD 309 User Manual 40 Figure Appendix 1 4 Map virtual serial port ...
Page 46: ...MD 309 User Manual 46 Figure Appendix 2 6 Map virtual serial port in vircom ...
