Care and Maintenance
Cleaning After Use
Clean and disinfect your tanning bed’s bench and canopy after each
use. Use a non-abrasive disinfectant cleaner that
does not contain
ammonia or ammonia derivatives
. Ammonia may damage the acrylic
shield. Spray the acrylic lightly with disinfectant and wipe dry with a
clean soft cloth. Wipe the canopy grill with a soft cloth slightly damp-
ened with disinfectant, then wipe dry.
Thorough Periodic Cleaning
The cooling fans draw air through the bed and will cause a dust
buildup on the lamps and reflectors. When a dust buildup is observed,
it is necessary to thoroughly clean the inside of the bench and canopy.
1
Remove the acrylic shield, metal grill and lamps.
2
With a soft cloth, wipe the entire length of each lamp.
3
Clean both sides of the acrylic shield and grill with a non-ammo-
nia disinfectant cleaner.
4
Wipe the reflectors with a clean damp cloth.
5
Re-install the lamps, acrylic shield and grill.
Mechanical Inspection
Inspect the unit’s mechanical integrity every 400-500 hours of use.
• Inspect the unit’s fasteners verifying that all are firmly in place.
Pay particular attention to the hinge bolts.
• Inspect gas springs for signs of wear. Replace gas springs that will
not hold the canopy in the full open position when raised.
• Inspect the AC power cord and its connections.
• Inspect the acrylic. Replace if broken, cracked or badly scratched.
Removing/Replacing Acrylic Shield (bench)
The acrylic shield in the bench and metal grill in the canopy are
secured in place by hinged profiles which run the length of the bed,
both front and back. Simply pry up on the inside edge of the profile
until it releases its latching action (see figure below). Continue to pry
up the profile across its entire length until it swings back freely. Repeat
for the other profile. The long edges of the acrylic shield are now
exposed. Standing in front of the sunbed, grasp the long exposed edge
of the acrylic and carefully slide it toward you until it is removed.
Removing/Replacing Canopy Grill
Follow the above directions for opening the hinged profiles. As you
pry the hinged profile open the canopy grill should start to drop out
on its own. If you need to, slide the grill toward the head or foot end
of the sunbed and it will drop out easily.
After changing the lamps, replace the bench acrylic shield and canopy
grill by reversing the above directions. Close the hinged profile by
pushing it back into place until it snaps tight.
PROFILE
CAUTION
Be careful. The edges of the
acrylic shield may be sharp.
Start pulling from the
middle of the profile!
A Timer display
- Displays remaining time.
B Timer button
- Turns bed on. Timer dis-
play shows remaining time. If a lesser
time is desired, press timer button
until desired time is displayed.
C Stop button
- Interrupts tanning session.
1
Press the timer button (B) to begin the tanning session. The timer dis-
play (A) displays the remaining time. The lamps will turn on and the
timer will begin to count down from the maximum tanning session
time. If a tanning time less than the displayed time is desired, repeat-
edly press the timer button (B) to decrease the remaining time.
2
Lift the canopy, lie down on the bench (face up), lower the canopy
as close to your body as possible.
3
When the timer reaches “0” the lamps turn off. If you want to stop
your session before time expires, press the stop button (C).
4
Raise the canopy by pushing the outer edge of the canopy.
Operation
This sunbed is equipped with a control key lock directly below the
timer, allowing you to monitor usage by children and/or others. To
activate, insert the key into the lock and turn, horizontal to lock and
vertical to unlock. You may remove the key in either position.
A
B
C
Using Your Sunbed
Before using your sunbed, please note the following:
• Your skin should be free of cosmetics, tanning oils, or other body
lotions prior to tanning except for those specifically made for use
with tanning devices. However, do not remove natural body oils by
bathing or showering immediately before tanning.
• Keep treated hair from contacting sunbed surfaces. Many hair prod-
ucts can damage the sunbed acrylic. Wear a shower cap or towel if
you use gels, mousses, sprays, or other hair products.
• Your sunbed is designed for individual use. Always wear the safety
goggles supplied with your sunbed or another approved pair of gog-
gles, as defined under 21 CFR 1040.20. Regular sunglasses do not
provide adequate protection from ultraviolet light.
Exposure Times
Follow the guidelines for skin type and exposure times as shown in the
table below. Untanned persons should not tan on consecutive days
during their first week of tanning. Never tan more than once a day.
Tanning normally appears after the first few sessions and maximizes
after approximately four weeks. Tan once or twice per week thereafter
to maintain appearance. Persons already having a base tan may begin
at advanced levels corresponding to the extent of their base tan.
Skin Type:
I
Sensitive Skin
(Burns easily and severely and does not tan.)
II
Light Skin
(Burns easily and severely and tans minimally.)
III
Normal Skin
(Burns moderately and tans average.)
IV
Dark Skin
(Burns minimally, tans easily and above average.)
RECOMMENDED EXPOSURE TIMES IN MINUTES
Level 1/Week 1
Level 2
Level 3
Level 4
Level 5
Skin Type: 1st-3rd Sessions
I
Sensitive
NOT RECOMMENDED FOR TANNING
II
Light
4
8
12
16
20
III
Normal
6
10
15
20
20
IV
Dark
8
12
16
20
20
MAXIMUM EXPOSURE TIME IS 20 MINUTES