27330-01A
Parts List
This is a list of parts which may be replaced by the
consumer. When calling for parts, first state your
bed model as E548R. Then refer to this list and
preceding illustrations for proper identification.
Access Panel
Access Panel Key*
Acrylic, Bench*
(with aluminum frame)
Acrylic, Canopy*
(with aluminum frame)
Acrylic, Rear Lamp Module
Acrylic, Shoulder Tanner*
Ballast, 100W
(bench lamps)
Ballast, 160W
(canopy lamps)
Ballast, 80W
(shoulder tanner lamps)
Ballast, 400W
(face tanner lamps)
Body Fan
(complete kit)
Capacitor, 75uF
Contactor
Cover, Canopy*
Current Sensor
Damper*
Endcap, Bench Foot End
Endcap, Bench Head End*
Endcap, Canopy Foot End
Endcap, Canopy Head End
Endcap, Rear Lamp Module Foot End
Endcap, Rear Lamp Module Head End
Fan, 6”
Fan, Round
Fan, Square
Filter*
Handle Kit*
Hardware Kit, Assembly*
Hardware Kit, Canopy*
Hour Counter*
Ignitor
Lamp Holder w/ Starter
Lamp Holder w/o Starter
Lamp Holder, Face Tanner*
Lamps*
Panel, Left Pedestal Front
Panel, Right Pedestal Front
Pillow*
Relay
Remote Connection PCB
Remote Control Bypass Plug*
Schematic Packet*
Shoulder Tanner
(complete kit)
Shroud, Body Fan Inside
Shroud, Body Fan Outside
Shroud, Shoulder Tanner Inside
Shroud, Shoulder Tanner Outside*
Speakers
(pair)
Starter, K-12*
(main lamps)
Starter, S-2*
(shoulder lamps)
Support, Bench Acrylic*
(“kickstand”)
Thermostat*
(for face tanner)
Timer
Timer Interlink PCB
Timer Keypad Kit*
(circuit board)
Timer Keypad Pushbuttons*
Trim, Bench Front
Trim, Canopy Front*
Warning Label
(English)
Warning Label
(French)
Wiring Harness, Keypad Link
Wiring Harness, Remote PCB to Timer*
Wiring Harness, Resistor Code*
Wiring Harness, Timer in Tray
Wiring Harness, RJ-11 Canopy to Bench*
*
Not shown
