28940-01A
2
Installation - Pre-Installation Planning
Pre-Installation Planning
Before you begin to assemble your sunbed, you should observe the following consid-
erations.
WARNING
Shock hazard.
Disconnect power before
servicing.
Air from the room is used to cool
the sunbed. Maximum ambient room
temperature should be 80°F. Place
your sunbed no closer than 6” from
any wall. Make sure nothing
obstructs the airflow into or out of
the fan openings. A poorly ventilat-
ed room may cause the unit to
become hot and cause discomfort
to the user.
CAUTION
Use of a voltage source above 230V
AC may prevent proper operation of
the sunbed and could cause damage
and void the warranty.
CAUTION
Proper assembly of your sunbed
requires three people. Plan to have
a couple of helpers assist you.
CAUTION
• The
Rejuvasun™ 332 with Omnilux™
requires a dedicated circuit capable of
providing
30 Amp
service at
220VAC
.
This unit must be hardwired directly to
a junction box on a dedicated circuit.
We recommend connection by a pro-
fessional electrician.
• IMPORTANT! Voltage must be below
230V AC or may require a Buck Booster.
• Some portions of the carton may be
used for assembly. Do not discard car-
tons until assembly is complete.
• You will need a #2 Phillips screwdriver
to assemble this tanning bed.
