28940-01A
19
(Operation while connected to a T-Max® remote
system. If using other remotes or no remote sys-
tem, see left.)
Note:
See Remote Connections for important
information about the T-Max remote system.
1.
Lift the canopy, lie down on bench (face up),
lower the canopy toward your body using the
handle. For best results, position the canopy as
close to your body as possible, maintaining at
least 4” (10.2 centimeters) from your body.
2.
Put on your safety goggles.
3.
Assuming the remote system has been set to
allow a pre-tanning delay time, the timer dis-
play (E) will repeatedly flash the delay symbol
“dL” and then the remaining delay time. Press
the timer button (G) or wait until the delay time
has expired to begin the session. The lamps will
turn on and the timer will begin to count down.
4.
If Rejuvasun is enabled, only the body lamps
and Rejuvasun panel will light. The display will
show the tanning time. If a tanning time less
than 20 minutes was entered with Rejuvasun
on, the tanning lamps will shut off when the
timer reaches “0” then the remainder of the 20
minute rejuvenation session will show. When
the timer reaches “0” the lamps turn off. If you
want to stop your session before time expires,
press the stop button (F).
5.
Raise the canopy by using the outer edge of
the canopy, do not push up on the acrylic
shield. The cooling fans run for a period of
time after the lamps shut off to aid in cooling
the sunbed. The timer will indicate “..” as a
reminder to clean the sunbed. After the
sunbed is cleaned press the timer button and
the display will return to “0”.
Operation - Using Your Sunbed
(Operation as a stand-alone unit or connected to
a remote system using a control relay. If using T-
Max® see right.)
1.
Lift the canopy, lie down on the bench (face
up), lower the canopy toward your body using
the canopy handle. For best results, position
the canopy as close to your body as possible,
maintaining at least 4” (10.2 centimeters) from
your body.
2.
Put on your safety goggles.
3a.
For tanning only, press the timer button (G,
previous page) to begin tanning.
3b.
For Rejuvasun only, simply press the the
Rejuvasun button (B).
3c.
For tanning and Rejuvasun, press the timer but-
ton (G) and then the Rejuvasun button (B). The
face tanners will not operate while the
Rejuvasun panel is on.
Pressing the timer button (G) repeatedly
reduces the tanning time only. The Rejuvasun
panel runs for 20 minutes regardless of the tan-
ning time.
4.
When the timer reaches “0” the lamps turn off.
If you want to stop your session before time
expires, press the stop button (F). You will have
ten seconds to restart with the remaining time,
otherwise the timer will reset to “0”.
5.
Raise the canopy by using the outer edge of
the canopy, do not push up on the acrylic
shield. The cooling fans run for a period of
time after the lamps shut off to aid in cooling
the sunbed.
