MODEL 4310 CCTV
© ETS-LINDGREN L.P. – DECEMBER 2003
REV A – PN 399280
SAFETY SYMBOL DEFINITIONS
!
REFER TO MANUAL
When product is marked with this symbol refer to instruction manual for
additional information.
HIGH VOLTAGE
Indicates the presence of hazardous voltage. Unsafe practices could
result in severe personal injury or death.
PROTECTIVE EARTH GROUND (SAFETY GROUND)
Indicates protective earth terminal. You should provide an uninterruptible
safety earth ground from the main power source to the product input
wiring terminals, power cord, or supplied power cord set.
CAUTION
Denotes a hazard. Failure to follow instructions could result in minor
personal injury and/or property damage. Included text gives proper
procedures.
GENERAL SAFETY CONSIDERATIONS
BEFORE POWER IS APPLIED TO THIS INSTRUMENT, GROUND IT
PROPERLY
through the protective conductor of the AC power cable to a
power source provided with protective earth contact. Any interruption of
the protective (grounding) conductor, inside or outside the instrument, or
disconnection of the protective earth terminal could result in personal
injury.
BEFORE SERVICING: CONTACT ETS-LINDGREN
– servicing (or
modifying) the unit by yourself may void your warranty. If you attempt to
service the unity by yourself, disconnect all electrical power before
starting. There are voltages at many points in the instrument which
could, if contacted cause personal injury. Only trained service personnel
should perform adjustments and/or service procedures upon this
instrument.
Capacitors inside this instrument may still be CHARGED
even when the instrument is disconnected from its power source.
FUSE
2 A : 250 V T
F U
S E
FU
SE
TO AVOID A SAFETY HAZARD
, replace fuses with the same current
rating and type (normal blow, time delay, etc.). Order any replacement
parts direct from ETS-Lindgren.
ONLY QUALIFIED PERSONEL
should operate (or service) this
equipment.
STOP
IN EVENT OF EMERGENCY
power unit down.
CAUTION
WARRANTY
