Eton CORE A2, Instruction Manual

Page: 41 / 48

41
Note: If you are having problems after installation follow the Troubleshooting procedures below.
Procedure 1:
Check Amplifier for proper connections. Verify that POWER light is on. If POWER light is on skip to
Step 2, if not continue.
1. Check in-line fuse on battery positive cable. Replace if necessary.
2. Verify that Ground connection is connected to clean metal on the vehicle‘s chassis. Repair/replace
if necessary.
3. Verify there is 10 V to 14.4 V present at the positive battery and remote turn-on cable. Verify quality
connections for both cables at amplifier, stereo, and battery/fuseholder. Repair/replace if necessary.
Verify there is 10 to 14.4 Volts present at the remote wire when system/ radio is on.
Procedure 2:
Protect light is on:
1. If the SC Protect LED is on, this is a sign of a possible short in the speaker connections. Check for
proper speaker connections and use a volt/ohm meter to check for possible shorts in the speaker
wiring. Too low of a speaker impedance may also cause Protect to light.
2. If the DC Protect LED is on, there is a defect with the amplifier. Plug out all electric wires! Please
disconnect the battery before! Search for an ETON dealer, you can find an ETON dealer at our web-
site www.etongmbh.com.
TROUBLE SHOOT
EN