GENERAL
1
M-423-05R
Black-Topper Shooter II
Operation Maintenance and Safety Manual
WARRANTY
E. D. Etnyre & Co. warrants to the original Purchaser, it’s new product to be free from defects in material and workmanship for a period of
twelve (12) months after date of delivery to original Purchaser. The obligation of the Company is limited to repairing or replacing any defective
part returned to the Company and will not be responsible for consequential damages or any further loss by reason of such defect.
The company excludes all implied warranties of merchantability and fitness for a particular purpose. There are no warranties, express or implied,
which extend beyond the description of the goods contained in this contract.
This warranty does not obligate the Company to bear the cost of machine transportation in connection with the replacement or repair of defective
parts, nor does it guarantee repair or replacement of any parts on which unauthorized repairs or alterations have been made or for components not
manufactured by the Company except to the extent of the warranty given by the original Manufacturer.
This warranty does not apply to:
(1) Normal startup services, normal maintenance services or adjustments usually performed by the selling dealer, factory service representative
or customer personnel.
(2) Any product manufactured by E. D. Etnyre & Co. purchased or subjected to rental use.
(3) Any product or part thereof which shows improper operation, improper maintenance, abuse, neglect, damage or modification after shipment
from factory.
(4) Any product or part thereof damaged or lost in shipment. Inspection for damage should be made before acceptance or signing any delivery
documents releasing responsibility of the delivering carrier.
This warranty and foregoing obligations are in lieu of all other obligations and liabilities including negligence and all warranties of merchant-
ability or otherwise, express or implied in fact or by law.
WARNING
Fluoroelastomer Handling
Some O-rings and seals used in this vehicle
are made from fluoroelastomers, When used
under design conditions, fluoroelastomers do
not require special handling. However, when
fluoroelastomers are heated to temperatures
beyond their design temperature (around 600º
Fahrenheit), decomposition may occur with the
formation of hydrofluoric acid. Hydrofluoric acid
can be extremely corrosive to human tissue if
not handled properly.
A degraded seal may appear as a charred or
black sticky mass, Do not touch either the seal
or the surrounding equipment without wearing
neoprene or PVC gloves if degradation is
suspected. Wash parts and equipment with
10% lime water (calcium hydroxide solution) to
neutralize any hydrofluoric acid.
If contact with the skin occurs, wash the
affected areas immediately with water. Then
rub a 2.5 calcium gluconate gel into the skin
until there is no further irritation, while seeking
prompt medical attention.
Note to Physicians: For advice or treatment of
HF burns, call the DuPont Medical Emergency
number, 1-800-441-3637
WARNING
Do not use this machine for any operation
which is not described in this manual.
If you have any questions about operation of
this machine, contact the Etnyre Service
Department at 1-800-995-2116 or
1-815-732-2116.
Operations that are not approved could cause
serious injury or death.
Please note this warning and remember -
Always start and operate the engine in a
well ventilated area;
If in an enclosed area, vent the exhaust to
the outside;
Do not modify or tamper with the exhaust
system.
CALIFORNIA
Proposition 65 WARNING
Diesel engine exhaust and some of its constituents
are known to the State of California to cause cancer,
birth defects, and other reproductive harm.
Summary of Contents for Black-Topper Shooter II
Page 3: ...2 ...
