ETNA VV856 Series, Instructions For Use Manual

Page: 39 / 52

EN 15
Changing the side on which the door opens
When changing the side on which the door opens, the appliance must be disconnected
from the mains power.
Tools
8 mm
10 mm
1. Remove the two screws on the back of the top cover.
2. Lift the top cover and place it on a padded surface to prevent scratching.
3. Remove the four screws.
4. Lift the upper hinge core, then put it in a safe place.
5. Lift the door and place it on a padded surface to prevent scratching.
6. Remove both adjustable feet and remove the bottom hinge bracket by unscrewing the bolts.
Then transfer them to another side.
Note: you need to install (if required) the rubber supporting A on the door on the side which
does not have a hinge.
Note: you need to move the hinge axis from hole B to hole C before you transfer the hinge
bracket to another side.
A
B C
7. Set the door into its new place making sure the pin enters the bushing at the lower frame
section.
INSTALLATION AND CONNECTION