ETNA KGG673ZTA, Instructions For Use Manual

Page: 15 / 36

EN 7
MALFUNCTIONS
SYMPTOM POSSIBLE CAUSE SOLUTION
Burner
extinguishes out
after igniting. You did not press the
control knob long and/or
deep enough (at least 3
seconds).
Thermocouple (3) is dirty.
Keep the control knob fully pressed for
at least 3 seconds between high and low
settings. This can be longer the first time,
because of the supply of gas.
Clean/dry the thermocouple.
Glass plate broken. Object fallen onto it. Close the gas main switch and pull the plug
out of the socket. Contact the your installer.
Where the GAD type examination certificates of KIWA refer to the appliance category
“I2EK” this is understood as:
This appliance was configured for the appliance category K (I2K) and is suitable for the use of
G and G+ distribution gases according to the specifications as included in the NTA 8837:2012
Annex D with a Wobbe index of 43.46 – 45.3 MJ/m3 (dry, 0 °C, upper value) or 41.23 – 42.98
(dry, 15 °C, upper value).
This appliance can moreover be converted and/or again be calibrated for the appliance
category E (I2E) This therefore implies that the appliance: “is suitable for G+ gas and H gas or
is demonstrably suitable for G+ gas and can demonstrably be made suitable for H gas” within
the meaning of the “Dutch Decree of 10 May 2016 regarding amendment of the Dutch Gas
Appliances Decree….”