ETNA A037VW, Manual

Page: 20 / 59

13
Things to watch for
Clean immediately
■ Any spillage should be removed
immediately, particularly red cabbage, apple
sauce and rhubarb. These can leave
permanent spots on the enamel or on
stainless steel.
Burning in of the enamel
■
The burners cause the saucepan supports
to get extremely hot. Over time the enamel
on the support points can burn in. This
cannot be prevented and is not covered by
the guarantee.
Burner caps
■ Check regularly to ensure that the caps of
the burners are properly in position on the
burner depressions; improper positioning
can make it difficult to light the burners, give
rise to an irregular gas flame, or damage the
burner caps.
Lighting the burners
While keeping the knob of the burner held in,
turn the knob to the left and light the burner
with a match. The gas flame can now be
smoothly adjusted from high to low.
Electrical spark switch (T007V/VF - T012VW)
■
Press the desired control knob and turn it to
the left to the maximum setting. Press the
ignition until the burner ignites.
Electrical spark switch (T017VW)
■ Press the knob of burner in and turn it to the
left to the symbol. The spark switch will
generate sparks and the burner will light
automatically. If the burner fails to light
after repeated attempts, check to ensure
that the burner cap is properly positioned.d .
Thermocouple protection (T007VB)
This appliance is fitted with a thermocouple.
This is a thermoelectric protection system. It
ensures that the gas tap is closed if the flame
goes out.
■ Press the desired control knob and turn it to
the left to the maximum setting. Hold the
control knob pressed in for 5 seconds. Press
the ignition until the burner ignites.
SAFETY/OPERA
TING
Burner cap
Burner ring
Spark plug
Burner casing
Injector
Thermocouple