PROGRAMMING INSTRUCTIONS (MODEL 20700)
TouchPad
The numbered touchpad operates on the capacitance of your skin and is very accurate in sensing the
pressure of a touched area. Very little pressure is needed to operate this sensor. However, when using the
numbered touchpad, the entire area of the number should be covered with your finger. This will ensure an
accurate number is input every time it is used.
Biometric Sensor
The fingerprint sensor maps your specific fingerprint using capacitance technology and computer
algorithms. This technology is very accurate when a “good” fingerprint is captured, and is not easily fooled
by counterfeits. In order to capture a “good” fingerprint, adequate pressure should be applied when first
enrolling a new fingerprint, i.e. enough pressure should be applied so that the entire face of your finger is
flat on the sensor. This will ensure that the sensor captures a good fingerprint and reduces the chance of an
enrolled fingerprint being denied access.
Setting Administrator Pin and Fingerprint
Once you are ready to program your Wall Vault™, the Administrator will need to be chosen. The
Administrator should be the primary user of the vault. The Administrator will be the only one allowed to add,
delete, or modify users. For security purposes, there can only be one Administrator.
1.
Press ‘*’ button and wait for five (5) seconds.
2.
Press ‘1’ and hold for three (3) seconds. One (1) beep, followed by three (3) beeps will indicate the
system is in Admin Mode.
3.
Enter current pin number (default is 1 2 3 4 4) and press the ‘*’ button
4.
Enter new pin number (must be 5 digits in length and can not include ‘*’ button as part
of pin) and press the ‘*’ button
5.
Re-enter pin number followed by the ‘*’ button. Green light will flash.
6.
With green light flashing, immediately place finger on biometric sensor. Center and place finger
parallel with biometric sensor pad. Once finger is recorded, beep will sound. The Administrator
fingerprint is now recorded. This fingerprint will be required to add new users.
7.
Biometric sensor will store one (1) Administrator fingerprint and five (5) additional user prints.
8.
If at any point during Programming you see a Red light, repeat steps 1-6.
9
10.ai 2/14/2005 11:34:07 AM
