PREPARING THE SETUP
Page 12
Setup Guide 9023409-01
Ethernet ADSL Cellular Routeur Firewall
HTTPS set-up modifications through the WAN interface
The administration web server is located at the LAN IP address.
Coming from factory, access to the administration web server is not allowed through the WAN interface
To use HTTPS instead of HTTP to setup the product or to authorise access to the administration web server
through the WAN interface,
•
Select Configuration > Security > Administration rights.
•
Enter an administration identifier and password.
•
Check the “HTTPS configuration” box.
•
Check the “WAN access“ box if you wish to access to the administration web server through the WAN
interface.
Remark : the port Nr used to access to the administration web server with HTTPS is 4433.
Exemple :
https://192.168.38.191:4433
.
Recovering the factory LAN IP address
•
Press the rear panel push-button ;
The OPERATION led indicator will flash.
The factory IP address 192.168.0.128 will be restored but the current configuration remains active.
Restoring the factory set-up
If firewall rules have been created finally preventing from reaching any IP address on the LAN interface
including the router itself, it may be necessary to restore the factory configuration of the router.
To restore the factory configuration,
•
Switch OFF the power supply of the router RAS.
•
Press the rear panel push button and, switch-on the power supply.
•
Keep the push button pressed until the operation led turns red.
Remark : The curent configuration is cleared and the factory IP address 192.168.0.128 is restored.