Etic Telecom RAS Series, Setup Manual

Page: 15 / 74

SETUP
DOC_DEV_Router setup guide_A
page 15
SETUP
1 Ethernet / WAN interface setup
This section applies to the below routers:
IPL-E, IPL-EW, IPL-DEC, SIG-E, RAS-E, RAS-EC, RAS-EW, RAS-ECW.
Il s’applique aussi aux routeurs IPL -A ou IPL-C lorsque l’on souhaite utiliser l’interface RJ5 N°1 comme
interface WAN au l ieu de l’interface ADSL (IPL - A) ou l’interface cellulaire (IPL -C).
• Select the Set-up > WAN menu
« WAN type » list :
Select the “Ethernet” value.
Ethernet WAN port configuration
« Speed / Duplex» parameter :
Select 10 or 100 Mb/s & full or half duplex.
IP set-up of the Ethernet WAN port
« Connection type » list :
The Ethernet value is the default value.
It has to be selected when another router connected to the Ethernet/WAN interface of the ETIC Router is in
charge of routing the IP frames to the internet
The PPPOE value must be selected only in a particular situation :
When it is selected, the Router sets a PPP connection over Ethernet towards a service provider for instance.
It is useful when a modem, not supporting PPOE, is connected to the Ethernet WAN port of the Router.
Do not select PPOE except in the situation described above.