EtiamPro HAA54, User Manual

Page: 8 / 45

HAA54
V. 02 – 27/04/2020 8 ©Velleman nv
7. Installation
Mounting Location
• The detector can be mounted on a flat surface (e.g. a wall)
or in a corner. Select a stable surface.
• This detector should only be used indoors and should be
installed in an environment that is shielded from the
elements.
• Do not expose the device to cold or warm air currents.
• Do not aim the detector at heating devices, air conditioning
vents, windows, refrigerator or freezer grilles or any other
surface that is subject to violent and sudden changes in
temperature.
• Do not place large objects in front of the detector, as this
will significantly diminish the area protected by the
detector’s beams.
• Select a mounting location that allows you to place the
detector at an angle of 45° (= optimal) with reference to the
intruder’s expected path. The detect or should preferably be
mounted in a corner.
• Installation height: 2 to 3 m (7 to 10 ft).
Removing the Front Cover
1. Loosen the screw.
2. Insert the tip of a screwdriver into the latching slot and
release the front cover.
3. Remove the front cover.
Removing the PCB
The PCB should be removed before mounting the back cover.
1. Loosen the fixing screw of the PCB.
2. Push the PCB upward until the head of the screw will pass
through the opening.
3. Remove the PCB carefully.
Mounting the Back Cover
The back cover is suited for wall or corner mounting.
1. Feed the power cord through the push-out hole at the top
and on the inside of the back cover.
2. The push-out holes at the back are suitable for surface or
wall mounting. The ones at the sides are suitable for corner
mounting.
3. Mount the back cover.