ETI 54465141, Use And Care Manual

Page: 3 / 19

4
5 www.ETiSSL.com
Please contact 1-855-384-7754 for further assistance.
HARDWARE INCLUDED
noTe: Hardware not shown to actual size. Hardware for motion sensor installation is not included, please contact ETi for separate purchase.
Part Description Quantity
AA Mounting Screw 4
BB Drywall Anchor 4
CC U Bracket 2
DD V Clip* 2
EE Cord Grip 1
FF Wire Connector 5
GG Chain* 2
HH S Hook* 4
* For suspension mounting only
AA BB CC
DD EE
installation
Select a suitable location that can support the weight of the fixture. Determine the method for mounting the fixture before drilling, based on
the type of ceiling.
WarninG: RISK OF ELECTRIC SHOCK. Ensure the electricity to the wires you are working on is shut off. Either remove the
fuse or turn off the circuit breaker before removing an existing light fixture or installing the new one.
1
Removing the lens cover
□
Remove the lens cover (A) by opening the 10 stainless steel clips on both sides of the fixture body (B).
2
Preparing the fixture for installation
□
Twist the two white plastic locks to detach the LED plate
from the fixture body (B).
□ Flip the LED plate over into the lens cover (A) to access
the electrical box on the back.
3
Installing the cord grip
□
Remove the nut from the end of the cord grip (EE) and
insert the threaded end into the knock out hole on the end
of the fixture body (B).
4
Feeding the wires
□
Feed the wires from the electrical
source through the cord grip (EE) and
into the fixture body (B).
□
Tighten the nut onto the cord grip
(EE) to secure the wires.
FF GG HH
pre-installation (continued)
Stainless Steel Clips
installation (continued)
A
B
EE
LED Plate
LED Plate
B
B
LED Plate
B
EE