4
5
www.ETiSSL.com
Please contact 1-855-384-7754 for further assistance.
installation
Option a
Option B
FF
A
A
EE
A
A
AA
A
AA
4
Making the electrical connections
nOTe:
This fixture is intended for use with an electrical box, conduit, and conduit connectors that are UL rated for wet locations and are
properly installed and grounded.
□
For electrical wires coming from the wall at the position of the fixture, feed the wires from the wall through
the vertical opening on the end of the wire cover. See Option A drawing below.
□
For electrical wires running through conduit or a raceway from an electrical box mounted to the wall, feed
the wires through the horizontal opening in the bottom of the wire cover. See Option B drawing below.
□
Connect the hot and neutral (black and white) wires from the fixture arm on the area light (A) to the same
color wires from the electrical box in the wall.
□
Connect the green wire from the fixture arm on the area light (A) to the grounding wire from the electrical
box in the wall.
□
Cover the wire connections using the wire connectors (AA).
□
Wrap the wire connectors (AA) with electrical tape for a more secure connection.
nOTe:
If electrical box wiring does not include a ground wire, consult your local electrical code for approved grounding methods.
1
Attaching the mounting screws
to the wall
For new installation:
□
Mark the hole locations on the wall using the
included template (CC).
□
Drill 3/16 in. diameter pilot holes at the marked
locations, ensuring that the two screw positions at
the bottom are level with each other.
For replacement installation or for new installation:
□
Install two hexagon socket mounting screws (BB) in
the bottom holes, leaving about 3/8 in. space under
the head.
nOTe:
Hardware included is for mounting to wood surfaces
only. Ensure that the fixture is mounted onto a structurally
sound surface that will support the fixture.
2
Preparing the fixture for
mounting
□
Remove the wire cover from the fixture
arm on the area light (A) using the M8
allen wrench (FF).
□
Put the wire cover screws aside until
ready for reassembly in a later step.
3
Mounting the light fixture
□
Slide the mounting bracket on the fixture arm of the
area light (A) onto the two bottom hexagon socket
mounting screws (BB) inserted in the wall.
□
Install the third hexagon socket mounting screw
(BB) at the top of the mounting bracket and tighten
securely using the M6 allen wrench (EE).
□
Tighten the two hexagon socket mounting screws
(BB) at the bottom of the mounting bracket on the
fixture arm with the M6 allen wrench (EE).
WarninG:
RISK OF ELECTRIC SHOCK. Ensure the electricity to the wires you are working on is shut off. Either remove the fuse or turn off
the circuit breaker before removing the existing light fixture or installing the new one.
With power disconnected to the electrical box, remove the existing fixture. Make a sketch of how the current
fixture is wired (by wire color) or mark the wires with masking tape and a pencil so you will know how to properly
reconnect the wires to the new LED light fixture.
nOTe:
Recommended installation height is 3.9 ft. or above.
Wire cover
screws
Wire
cover
Fixture
arm
Mounting
bracket
Wire
cover
Wire
cover
installation (continued)
Wire
cover
