6
7
ETiSSL.com
Please contact 1-855-384-7754 for further assistance.
A
CC
5
Preparing the fixture body for mounting
□
Attach the hook on one end of the cable set (BB) to a hanging hole on the fixture body (A) and close the hook with pliers to
secure it.
□
Attach the hook on the other end of the cable set (BB) to the other hanging hole on the same end of the fixture body (A) and
close the hook with pliers to secure it.
□
Attach the S-hook on one end of the mounting chain (CC) to the center of the cable set (BB) and
close the hook with pliers to secure it.
□
Repeat these steps with the second cable set (BB) and mounting chain (CC) on the
opposite end of the fixture body (A).
CC
BB
BB
suspension Mounting (continued)
suspension Mounting (continued)
7
Making the electrical connections
□
Feed the electrical wires from the fixture (A) through the cover plate (AA).
□
Connect the hot and neutral (black and white) wires from the fixture body
(A) to the same color wires from the electrical box.
□
Connect the green wire from the fixture body (A) to the grounding wire from
the electrical box.
□
If 0-10v dimming circuit is available, connect the purple and gray wires
from the power supply box to the same color wires from the electrical box.
□
If dimming is not desired, wrap the ends of the purple and gray wires with electrical
tape to cover the wire.
□
Cover the wire connections using the wire connectors (EE).
□
Wrap the wire connectors (EE) with electrical tape for a more secure connection.
□
Position the wires back inside the electrical box and attach the cover plate (AA) to the
electrical box using the electrical box screws (DD).
8
Restoring power
□
Restore power at the electrical panel.
□
Turn on the light switch to activate the fixture.
1
Removing the power supply box
□
Remove the four screws that attach the power supply box to the LED fixture body (A) using the power tool hex bit (FF).
□
Put the screws aside as they will be needed to reattach the power supply box to the fixture body (A) in a later step.
□
Lift the power supply box from the fixture body (A) and unplug the Quick Connect wires.
surface Mounting
Power Supply Box
Quick
Connect
A
Power Supply Box
A
FF
DD
AA
CC
BB
A
A
CC
6
Attaching the chain to the ceiling
□
Hang the fixture body by placing one chain (CC) over each hook (not included) that has been installed on the ceiling.
□
Adjust the chains to level the light. The fixture must hang at least 3 in. from the ceiling.
□
Feed the wiring through an appropriate conduit based on local electrical code.
CaUTiOn:
Check local electrical code to determine the appropriate type of conduit for the wiring. Do not leave the wiring exposed.