KL8-3H-CAA6/KL8-3H-BAA6
www.ethink-spa.com
6
15 ~ 42
℃
。
5
）
After all the set and then click
“
”
Button to confirm
，
the system automatically set the
status from the pre-heating
。
*** Note ***
1, pre-heating of all the settings and work must be in the waiting state
。
2, please refer to LCD is the display
“
ON
”
or
“
OFF
”
，
shows
“
ON
”，
said pre-heating is
turned on when the pre-heating start working time and the current settings at the same clock
，
it will
start pre-heating
。
Shown as
“
OFF
”
at any time when it will not start pre-heating
。
3, set in the entire pre-heating process
，
the constant temperature furnace and water pump will
not start the work cycle
。
6
、
pre-heating of the work:
When real-time clock and pre-heating setting start working time consistent
，
pre-heating is set to
“
ON
”
and the bathtub with water
，
it will start the pre-heating
。
circulating pump and automatic
constant temperature system work at the same time
，
LCD display position on the countdown clock
time
（
“：
”
are no longer flashing
）
。
Work in the pre-heating process
，
when the end of the countdown time
，
the system automatically
shut down pre-heating
；
At this point you can also
“
”
Closed pre-heating
。
***Note***
1, when the temperature is too low (less than or equal to the water temperature)
，
although the
start of pre-heating
，
but the constant temperature furnace and the circulation pump will not start
。
2, each state (no water
、
still water
、
flowing water) switching time of 30 seconds
。
7
、
the work of circulation cleaning:
When the real-time clock and the setting start working time of circulation cleaning consistent
，
the circulation cleaning is set to
“
on
”
（
the mark
“
”
of LCD panel is on
）
，
and the bathtub
with water
，
it will start the circulation cleaning
，
At this point LCD display on the part of the countdown
time clock
（
“：
”
are no longer flashing
）
。
All the surf PUMPS and BLOWER will activate
，
the working time is 30 seconds
，
Synchronized to
start circulating pump
，
Ozone after 15 minutes of each work will be shut down for 15 minutes
。
In the course of the circulation cleaning
，
when the countdown to the end or
“
”
Key to
close the cycle of cleaning
。
8
、
on / off operation
In the waiting state by
“
”
Key to enter the working state
，
State in the working state by
“
” Can enter the waiting state
，
LCD display can be seen whether the state boot?
OFF
OFF
Figure 8
：
waiting state Figure 9
：
working state
